Soak with PB Blaster, it will become your friend.
if you put a chisel between knuckle and the shield hit it evenly from each side they usually pop out..
best of luck. took me 20 minutes one time.
SOURCE: front hub bearing removal 2002 dodge ram 1500 4WD 4.7L V8
i just did a 2002 2500 4x4 with a dana straight axle and had no problem getting on the bolts with a 9/16 12 point socket on a 6 inch extension. If you do not use an extension the head of the ratchet will hit the yoke of the axle shaft.
SOURCE: locate bolts to remove the strater of 1996 dodge caravan
Almost all starters have ears with holds in them that bolts go through to threaded holes in the bell housing. Find the starter and look around the end without the wires for the bolts.
SOURCE: Can power steering pump be removed by taking out
Dropping the strut should be sufficient......
SOURCE: how to remove front windshield from a 1996 ,2.4 liter Dodge Carav
There are tools to do this but you are better off having a pro take it off and re install it for you, granted he may charge the same price of almost 200 bucks to do so which is about the cost of a new windshield ( without any heating element in them for defrost) but it will save you grief, otherwise i believe they use a steel wire with two handles to slice the adhesive between the glass and body then they carefully push it out of the frame YOU MAY BREAK YOUR WINDSHIELD DOING THIS IF YOU HAVE NEVER DONE IT BEFORE.
Testimonial: "thank you for the advice ,it was well taken."
Fig. Fig. 1: Remove the right side inner fender splash shield 
Fig. Fig. 2: From below the vehicle, remove the accessory drive belts 
Fig. Fig. 3: If necessary, use a prying tool to wedge between the engine block and damper spoke hole, then loosen the center bolt 
Fig. Fig. 4: Remove the crankshaft damper center bolt and washer 
Fig. Fig. 5: Pull off the crankshaft damper, or remove using a 3-jawed puller tool 
Back to Top
61 views
Usually answered in minutes!
×