My trucks starts but keep quiting

I recommend starting with the basics. a lot of generators will not start or quit running if they are low on oil. check to make sure the oil level is correct before doing anything to the carburetor.

Have it scanned looking for diagnostic codes. Sounds like you could have a crankshaft or camshaft sensor problem, which will be a simple fix.

Before starting the engine, the fuel pump should only run for a few seconds when the key is first turned, to pressurize the fuel system. Even though the pump appears to be running, you may either have not enough or too much pressure for the engine to keep running (fuel pump or pressure regulator). I think it may just be a coincidence the engine quit while turning a corner, but the gas in your tank may have been so low it sloshed away from what is likely a very old pump, starving it and causing it to failure.

replace the crankshaft position sensor, it will cure the problem.

might b crank sensor it should throw a intermittent crank signal code

you have a bad intake gasket are a platuim gasket under the throttle body give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man.

does it have three second fuel pump run when you turn key to run position/ in between you should let i rest 5 or so seconds then try it again also some of these cadilacs have oil pressure sending unit wich takes the duty of keeping fuel pressure up is fuel pressure lowering as engine quits eg. rev up some in your few seconds of running while the engine is quit momentum keeps it turning for a short time see if you r pressure maintain thru the wind down

it is the black box on the drivers side of your fuel punp.they get hot and mess up,unplug the wires and mount on top.

you igniton modual is bad the one under the dash that connects to the key

Craigslist.. its FREE