Injectors not geting power have new fuel pump filter relay switch new ecm distrubter plugs coil changed out tbi unit with diffrent one same problem it runs sometimes and dies longest its ran is hour its a gmc serria 350 5.7 1992

SOURCE: 1995 JEEP GRAND CHEROKEE RAN AND DIED WILL NOT START

IS IT THE 4.0L?IF SO U MAY HAVE A BAD CRANKSHAFT POSITION SENSOR.

SOURCE: I have a 1991 Firebird V8 305 with TBI. Car was

Check your fuel pump relay

Dar

• 2007 Answers
• Posted on May 13, 2009

SOURCE: CAR WILL START AND RUN FOR A FEW SECONDS THEN DIES

Mass air flow sensor.

SOURCE: 1987 chevy s10 2.5l tbi will not start. changed

That eliminates the crankshaft and camshaft position sensors. Have you checked the fuel injector itself for an open winding or stuck valve plunger? There should not be a steady 12 volts to the injector--if good injector, it would be spraying fuel steadily into the throttle body. But at least the engine should try to run if poorly. Take the injector out, dry it off with air, and intermittently apply 12 volts to one terminal while grounding the other. You should hear a click from inside every time you touch 12 volts. If not, replace it. If it does, it may be plugged with debris. Try blowing through it in reverse with compressed air.

SOURCE: 90 chevy k1500 350 tbi fuel problem starts but wont stay running

try bypassing the oil pressure switch on the back of the block behind the distributor, if there oil pressure switch goes bad it will do this. had one that drove me nuts trying to fix it then figured out I had to buy a book and low and behold thee it was 3 wire oil pressure switch you can't see between the engine and fire wall just behind the distributor and costs 8 bucks to buy new.