SOURCE: 92 ACURA VIGOR
When you changed the joint, I'm assuming you had the shaft out. A common problem occurs when you put the shaft back in, it doesn't fully seat in the transaxle and then the differential is only connected to one wheel so it can't transmit power. You will have to disconnect the lower ball joint again, move the lower control arm down a bit, so that you can push the axle into the splines of the transmission.
SOURCE: 1994 acura vigor has abs and brakes lights on while driving?
Check for brake fluids and make sure all the brake fluid container is closed tightly. Also, you make have to bleed the brakes.
SOURCE: location of fuses for 92 acura vigor
they are below the driver side kick panel. It has a round latch turn over clock wise and pull cant miss it. Also there is another fuse box in engine compartment by the battery it has a cover pull it off.
SOURCE: how do you change the alternator belt
you need to loosen the alternator and the bottom bolt will allow the alternator to slide after that you can take the belt off
SOURCE: 1994 acura vigor
The front brake rotors are press fitted to the front wheel bearings and are removed from the car with a special tool (puller) or can be seperated by removing the whole assembly and placing it in a press to seperate them. You may damage the bearing if not done right.
252 views
Usually answered in minutes!
×