Multi-information display not working - 2004 Toyota Camry Solara

Multi Information Display not Working ' PriusChat

https://priuschat.com > Prius > Gen 3 Prius Care, Maintenance & Troubleshooting

Have you scanned vehicle got codes?

Ignition switch or relay should be killing power to this unit. Often power removal performs a reset of the device.

Press the "setup" button on the radio and scroll through the setting until you get to language settings, select the desired language and your set.

http://www.toyota120.com/html/center_console_lights.html

Good luck!

If you really plan on chasing this one down as a DIY project, you will need electrical diagrams from your car. You can find these and a whole lot of other information here:
Haynes Avalon service manual
Even if you don't care to do your own maintenance, you can get an idea of the potential cost of a repair by looking into the complexity of it before committing to a sky-high repair bill.
We have a Haynes in each of three vehicles and they have saved us time and money.

yes, but if installed it only works in reverse. When remove from reverse it goes back to display

hi,
I have Toyota Avensis 2005 model. I have a problem with Multi information Display unit. It does not turn off even after switching off the car. The display unit is stuck with a figure. Please help me in fixing this and resetting the unit.
I tried long pressing the ENT button and all the range buttons, but no use - also changed the ODO display.
Thanks,
Raksha.

Oil Change Reset Procedure

1. Turn the "ENGINE START STOP" or engine switch OFF with trip meter A reading shown.
2. While pressing the trip meter reset button, turn the "ENGINE START STOP" switch or engine switch ON.

Without multi-information display

1. Continue to press and hold the knob until the trip meter displays 000000.

With multi-information display

1. Continue to press and hold the knob until "COMPLETE" appears on the multi-information display.

1. Set the "ENGINE START STOP" or engine switch OFF with the trip meter A reading shown.
2. While pressing the trip meter reset button, set the "ENGINE START STOP" switch or engine switch ON.

Without multi-information display

1. Continue to press and hold the button until the trip meter displays 000000.

With multi-information display

1. Continue to press and hold the button until "COMPLETE" appears on the multi-information display.

there you go jimmy mark as fixya