SOURCE: 2000 honda crv p1399 and p0301 check engine codes
CODE PO301 IS CYLINDER 1 MISFIRE DETECTED.POSSIBLE CAUSE.BAD PLUG AND WIRE.BAD COIL.BAD FUEL INJECTOR OR WORN VALVES TO THAT CYLINDER.OR LEAKING INTAKE AT THAT CYLINDER.
SOURCE: how do i fix this honda code P1457
Interior lights do not turn on when door is opened. I checked the fuses and they appear good
SOURCE: 2004 Honda CRV Check Engine light
the check engine lamp is not affected by things like tyres, brakes etc. It shows that the vehicles engine management system had detected a fault with the engine or engine sensors. Check the engine for broken or disconnected wiring (maybe it was disconnected during the replacing of the hoses but not reconnected). If you fail to locate anything, check the manual for the correct fault code retrieval procedure or take the vehicle to a professional. Tyres may affect your ABS system or Airbag systems but they usually have their own warning lamp and are unrelated to the check engine lamp..
SOURCE: 2002 Honda Accord V6 check engine light on- local
po505 idle air control if this is the code all hondas do it eventully, small problem easy fix u have 2 choices either remove the idle air control motor and clean the inside of it u will find it's black and the spring inside is stuck clean it with carb cleaner or gum cutter any parts store will have this it's a dirty job it will work for awhile but to replace it is recommended its not expensive for a new one which u can get at any autoparts store autozone,advanced,napa etc. there is only 2 bolts in most cases maybe 3 i doubt it though if u go online t google and type in th eyear make and model and engine size in ur case it's a 3.0 v6 and look for idle air control locations u'll find it to do this job a shop will charge u anywhere from 100.00 for diag to retrive the code plus the part and the labor so about 250.00-375.00 it will only take u honestly maybe 15 minutes to perform only tools needed are a 10 millimeter wrench there is only 1 connector to disconnect and ur done if u do this u will still have the check engine light because u have not cleared it from the computer to do this just disconnect the negative battery terminal (the black one or has a neg sign - don't disconnect the positive side +)for 5 minutes then reconnect and the computer will have reset no more light. good luck it really is that easy
SOURCE: reset honda crv check engine light
You can't reset it. That light is on because there's a problem with the emissions system,like a bad o2 sensor & such. Go to your local autozone & have them pull the trouble code out. Message back for the fix & the light will be out.
949 views
Usually answered in minutes!
×