Need to know how to locate and install 2001 mitsubishi galant 2.4l crankshaft position sensor
My car cuts off when it's sitting at a light or stop sign. What causes this?
The camshaft position sensor is located behind the harmonice balancer remove balancer and timing cover once removed you will see it u will also have to remove the crank gear and timing belt be sure to reset the timing or mark the gears before removal hope this helps
SOURCE: crankshaft position sensor location
Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.
SOURCE: where is the fuel filter located in the 2001 mitsubishi galant?
can you tell me where the fuel filter is located on a 01 mitsubishi galant?
SOURCE: Need help in locating starter on a 2001 mitsubishi
they at the back of the motor just at the top or could be at bottom at back of gearbox
SOURCE: need to know about changing the timing belt on my 2001 mitsubishi
This will take about 3-4 hours. If you look at the drive belts, they will all have to be taken off to get to the timing belt. The engine crankshaft has to be positioned for marks to line-up. The crankshaft will have to be prevented from turning so you can take off its drive pulley. Rotate until the alignment cylinder is near TDC, remove sparkplug, then packing a small rope on top of the piston prevents the engine from turning.. Once you change one timing belt, you will never buy another car with a timing belt again. You can get a manual on eBay.
SOURCE: Location of camshaft position sensor on 2004
On 1999 and later 2.4L SOHC engines it is located on the left end of the cylinder head (opposite end of the engine from the timing belt)
5,609 views
Usually answered in minutes!
×