2000 Mitsubishi Eclipse Problem TCL - 2000 Mitsubishi Eclipse

SOURCE: what is the TCL light

usually it means traction control but to be sure here is the number for mitsubishi. please call them to make sure.

For questions regarding your Mitsubishi vehicle, please contact Mitsubishi Motors North America, Inc. at 1-888-MITSU2009. Representatives are available Monday through Friday, 8 a.m. to 7 p.m. (CT)

SOURCE: dash lights dont work on 2000 mitsubishe eclipse

change out the water pump that should solve your problem for over heating.

SOURCE: 2000 Mitsubishi Eclipse will not idle, all else OK, just repl bat

I can only offer these few ideas.

1. The TP throttle position sensors for this year group fail often Pin 1 to Pin 4 resistance should be 3.6 to 6.3 ohms but you need to remove the two 7mm bolts that hold this sensor on the front side of the throttle body, then rotate the two bolstered center and see a change in resistance from low to high. If the resistance remains fixed, the sensor is rusted out and must be replaced.
2. The IAC motor is mounted on th LH side (driver's) of the throttle body. It should make a clicking sound when the key is turned from Lock to Run. Pin 2 to Pin 1, Pin 2 to Pin 3, Pin 5 to Pin 4, and finally Pin 5 to Pin 6 must all have continuity at 38 to 52 ohms.
3. Check for any vacuum leaks.
4. Remove clean and check EGR.
5. If this is a Cranks but will not start problem, check the owners manual for Theft Deterant UNLOCK proceedure. If there is power at the rear fuel pump relay coil and no power at the MFI/ASD front relay coil and no spark, then its the security system.

SOURCE: brake light bulb Mitsubishi Eclipse Cars

look for access panels in rear hatch there will be one on each side remove those and there will be 10 ml nuts holding the light housings on remove those then you can access the lights

SOURCE: Change a crankshaft position sensor on a 2000 eclipse

Is this a V6 or 4cyl???>>>(V6) This requires removing the Harmonic balancer (crankshaft pulley). Remove (R) front wheel, remove engine splash Guard, Remove crank pulley, remove lower timing belt cover. The Crank sensor is located behind the crank shaft pulley!! I highly recommend having this done by a certified tech, requires special tools. Hopefully this helps!!