I found the first one bolt but i can't locate the second one so can someone plz help
Remove the plate, then remove all the screws on the silver plate that is behind the license plate itself. There should be 4 other screws to remove. Once you have done this, open your trunk and partially remove the carpet behind the trunk etc--------------------------------------------------------------------------
Car Key Programmer
SOURCE: where is computer located on 1995 buick lesabre & whatis the seri
http://www.tradebit.com/filedetail.php/8617268-1995-buick-lesabre-owners-manual-instant
SOURCE: 98 Buick LeSabre won't start. Battery and
Remove the battery terminals and clean them real well and tighten them back on the posts. If you have a bad connection here, you will get the problem you described. When you are done, go ahead and put your starter back in. While you are down there, check the voltage on the thick wire supplying battery voltage to the starter make sure it is 12V. Try to start the car and get back to me.
SOURCE: where is the fuse box location 1989 buick lesabre
Hi J_livezey,
Your fuse box is located behind the right side of the dash,to the right of the glove box.Here is a diagram to better expalin.If you need anything else,let me know. Thanks,Chuck.
Testimonial: "thank you chuck very much worked great now if you can help me with my radio. posted you are great"
SOURCE: locations of fuse boxes in a 2003 buick lesabre
If it is like the 2002, one is in the engine compartment near the jumping post. The other is under the back seat.
SOURCE: where is the orifice tube on a 98 Buick LeSabre
not exactly sure but using info below you can find it.
Remember the flow for the a/c system is :
1. From the compressor a high pressure (HP) gas goes to the condenser in front of the radiator.
2. From the condenser a HP liquid goes to an expansion device (orifice tube or expansion valve)
3. From expansion device the low pressure gas enters the firewall to the evaporator.
4. From evaporator the low pressure liquid/gas mixture goes through the dryer back to the compressor suction.
There will be about a 1" nut on the low pressure line between the firewall and the compressor. Remove nut and on the male side use a pair of kneedle nose pliers and remove orifice tube. Note orientation of tube.
Replace tube, reassemble, evacuate air from system, recharge with freon.
72 views
Usually answered in minutes!
×