Toyota solara radio fades in and out of the station

https://www.google.com/search?source=hp&ei=AhXPXPTgNsjp_QbMo4zADA&q=2002+toyota+solara+radio+wiring+diagram&oq=2002+solara+radio+dia&gs_l=mobile-gws-wiz-hp.1.0.0i22i30l2j33i22i29i30.1220502.1227535..1228696...3.0..0.269.1950.16j4j1......0....1.......8..35i39j46i39j0i131j46j0j0i20i263j46i275j33i299j33i160.uWVjJVocvc8#imgrc=ACerBIciA8guyM:

You only get the info the radio station provides. Some send artist and song name others send more, some send nothing.

dead as in all functions and modes dead, all.
?
well it can only be 2 things
1: no 12vdc to head, (use a 10 buck voltmeter from walfart>?)
2: head end is dead.

25amps is the wrong, fuse. even 10 amps is good for 140watts.
the fuse is stated in the operators guide lost that?
some cars its mark,, RADIO.
the fuse that looks bad is
the fuse that looks good,can be , in fact. bad. what most techs
do is use ,yes, the voltmeter again, to measure bothsides of fues
keyon, radio on, to check all fuses related to radio (audio)
12v on both sides wins
if 12v makes it to the Radio and amp (if external amp then that too must have power, for sure) then the radio is bad, or amp.
if the radio scans and finds stations(not stated) then the amp might
be bad or lost power.

radio 101, over and out.

Sit in back seat passenger side. Remove panel which is on top which is below rear window, same panel where seat belt goes into panel at top. You will need to remove #2 Phillips screws which hold panel in place. Screws are hiding behind seat belt front cover where belt goes down in panel, under cup holder which allows arm rest cover to lift off and one more right on left side of head rest in corner. Remove panel. You will see switch which is in vertical position. If for any reason you want to by-pass switch, just unplug switch. Radio will still work in standard mode. The amp sound will not increase in performance when top is down and sound will not be as sharp.

It part of your rear window glass, did someone tinted your windows or aftermarket sound system aded?

Bad amplifier

ck antenna lead from redio to antenna make sure conncetions are good.. my have internal radio concens

Check mounting surfaces at antenna. Corrosion or looseness and the antenna loses its ground to the body.

THIS IS A RADIO PROBLEM, THIS PROBLEM WILL REQUIRE THE RADIO BEING SENT OUT TO AN AUTHORIZED FACTORY ELECTRONICS REPAIR CENTER, THERE IS NO BLOWN FUSE OR THE RADIO WOULD NOT EVEN TURN ON.

This is an antenna ground problem