Where is the crank sensor on 2000 buick lesabre and how do u replace it
SOURCE: how to replace a coolant level sensor, 2000 buick century
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
SOURCE: Can't find the pcv valve on a 2000 Buick LeSabre.
assume this is a 3800,pcv is on pass side of plastic intake manifold,small plastic locking collar has an arrow on it ,says pcv
SOURCE: 2000 buick lesabre - water pump replacement
first disconnect the battery then check how the serpentine belt is lined up so u can take it off and put back on. Then the pump should be on the side of the motor with 9or12 bolts there could be more! after taking out take razorblad and skrap the old gasket clean wipe of then put new gasket and pump back on dont over tighten the screws cuase the pump my be aluminum.
SOURCE: My car was diagnoised with a bad air flow sensor
the mass air flow sensor is located under the top plastic engine cover. to remove this un screw the oil filler tube by hand and remove the top cover. its just to the right of center engine. unplug this sensor. next it has two screws to take this off. It is not standard screws so look at it. remove them and replace sensor. After install go to autozone and have the warning code removed. This is done free. 2000 buick lesabre
SOURCE: 2000 Buick Lesabre custom liscense plate bulb
kind of tricky, took me an hour to get it figured out, but you got to opend the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together
853 views
Usually answered in minutes!
×