05 Gnd Caravan 3.3L - code: P0406

2005 Dodge Grand Caravan 3.8L engine misfire on cylinder 5.

answers.edmunds.com > Edmunds Answers

Aug 14, 2012 - MIL on; cylinder 5 misfire; most noticeable at idle in gear ... This could be caused by an EGR valve that is sticking partly open and not closing ...

OBD-II Trouble Code: P0305 Cylinder 5 Five Misfire Detected

www.obd-codes.com/p0305

A P0305 code means that the the car's computer has detected that one of the engine'scylinders is not firing properly. In this case it's cylinder #5.

ODB Code P0305- Misfire in #5 Cylinder - 2008 Dodge ...

repairpal.com > ... > Grand Caravan > 2008 Dodge Grand Caravan

Feb 22, 2011 - ... do something with a misfire in the #5 cylinder of my V6 4.0L engine. ... ODB Code P0305- Misfire in #5 Cylinder on 2008 Dodge Grand Caravan .... My2005 dodge grand caravan jerks when it shifts into gear what could it be.

My Dodge Grand Caravan has a Cylinder 5 Misfire,? ' Yahoo An

05 Dodge Caravan No Start P0688 bad wire - YouTube

? 10:49
www.youtube.com/watch?v=yshodC_crqo
Sep 22, 2012 - Uploaded by Brian Mann 2005 dodge caravan crank no start p0688 asd relay circuit ... butdoing the voltage drop on the back of the connector to the ipm to.... ECM PCM STARTER 2003 DODGE GRAND CARAVAN 3.3L V6 WONT START ... 1996, 97, 98 Dodge Caravan Starter install3.8L V6 - Duration: 8:39. by Gary O 4,364 views.

Replace the EGR valve. Very common code.

I would clear the code and see if it returns. If the EGR valve is stuck open, it would make it buck or shutter. If the EGR valve is not functioning right, or clogged up, it will effect proformance. I would replace the EGR valve. I read that it's a common problem.

It is most likely that your egr needs to be replaced

Off the top of my head I beleieve these are EGR codes, the EGR valve is located on the top front left side of the engine, you may need a valve and solenoid.

Here are the links: http://www.obd-codes.com/p0135

http://dodgeforum.com/forum/3rd-gen-ram/26914-p0406-exhaust-gas-recirculation-sensor-a-circuit-high.html

3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .

EGR position sensor circuit. Either you have a wiring issue or you need to replace EGR solenoid assembly. First check electrical connector at EGR solenoid for corrosion or broken wiring.

that code stems from egr valve, more than likely its getting "sticky" eventually could lead to being stuck open- just replace it. Its easy on a caravan right in front, 15mins. tops.