When I use my AC I Have absuletly no power to take off, the trany wont shift at all I replaced the shift solenoids and it still dont work
SOURCE: in my 2004 chevy suburban, the cd player wont work
Replace! The repair cost is probably more than replacing it with a decent JVC, Pioneer or Clarion unit - and you can get a DVD player as well to keep the kids occupied ;-)
SOURCE: none of the gauges work
You will need to install a new Instrument Panel Cluster. And GM just changed the programming of these IPC's to where you will need to take it to a GM dealership and let them program it.
SOURCE: 95 chevy suburban- brake lights not working (turn
There are a couple of types of switches but lets assume you have a more common one. It will be located on the left side of the brake pedal shaft it is black with 4 wires in one connector and a seperate 2 wire connector above the 4 wire connector. The switch is easily removed if it is this style by pulling it down it has 2 clips one at the top and one that slides over the pedal shat the back of the switch has a rased hump tha slides into a recess on the upper pedal support bracket.Grab switch pull down and gently wiggle it if necessary.Remove 4 wire connector and 2 wire connector. Now you are holding the old switch and yor troubles have just started the after market replacement switches really **** get a real gm swich.If you look at the old swich at its bottom you will see a little foot sticking out of the base of the swich once the new swich is installed you must use the little foot to adjust the swich.If you do this wrong you will do dammage to your transmission.The two wires at the top of the swich go to the transmission torque converter clutch.when the brake lights are on the upper swich is off. When brake lights are off the swich will be on.Get new swich installed using this info and get a pro to help you adjust it.It should cost you only 35 bucks to get it set.Dealer shouldnt charge more than 30 bucks for switch.
Good luck and thank you for using Fixya
SOURCE: speedometer not working cable good from trany to
THE SPEEDOMETER CABLE GOOD AND SPEEDOMETER NOT WORKING.2 POSSIBLE CAUSES WHILE ITS NOT WORKING SPEEDOMETER GAUGE BROKEN OR SPEEDOMETER DRIVE GEAR IN EXTENSION HOUSING BROKEN.
SOURCE: I can't find the rear ac expansion valve on my 95 chevy suburban?
Remove two trim panels from just inside back window and just inside rear side door passenger side. They run down from the head liner. Remove seat belt bolt ( TORX HEAD ) also. Remove lower half of trim from just inside rear side door. You should see screws holding weel cover in place. The top under glass just lifts up slightly to remove entire cover. Just a few more screws and you can hinge the top cover of the duct and fan. You will now see the top half of the rear condenser and if you look down beside it you will see the expansion valve. This about as close as you will get to changing the valve though because the freon lines running to the condenser will be stuck so solidly you would have to destroy the lines on either side of the nut to seperate them. You cannot reach the valve without lifting the condenser from its tray and you cannot lift the condenser without removing the lines from it!!! Good luck!!!
211 views
Usually answered in minutes!
×