My auto trans went out in my 87 jimmy and i have a 84 chevy with a manual trans, that im putting in my 87 jimmy. i bought a cluch pilot bbearing to put in the 350 and it already had one in there, im already in install the new fly wheel and ****** but not sure why there was already a pilot bearing on the automatic.
SOURCE: Chaning right wheel bearing on 1999 Chevy Malibu
It is much easier, and cheaper to find a steering knuckle or "hub assembly" in a salvage yard.
To begin, jack up the car and remove the wheel. Be certain the car is stable and will not roll off jack(s)!
Remove the spindle nut. Remove the brake caliper (hang on a wire).
Remove the bolt for lower ball join. Remove the bolt that goes thru
strut. Now, pull assembly off while prying to ease pressure from the
lower control arm.
Depending on how many miles you have on the car, you might want
to head-off some future trouble by replacing the half-axle while you
have the front end disassembled.
SOURCE: Need wheel bearing replacement
unfortunately your bearing assembly is a sealed unit and you have to purchase it as a complete part. they do have a way to change out the bearing at a shop, however the labor cost involved would most certainly be alot more than a replacement it's self. I have come across this problem many times and it's not as easy to switch them out as you have been told. i hope this helps. (note) to repalce them on your vehicle if you don't do the work yourself have a small shop do it not a dealer shop. the cost will be alot less. the labor time should be no more than 2 hrs. that is roughly about no more than 120- 150 dollars for the labor . if the place you take it to quotes you way more than that take it somewhere else... good luck please rate this
SOURCE: 96 FORD F-350 7.3 TURBO DIESEL 5 SPEED
A company in Northern Ireland called Exact Engineering will convert your dual mass flywheel to single mass.
See their website on www.exact-spec.com and email them on [email protected]
SOURCE: trouble finding transmition dipstick on 99 rodeo
pan has two plugs in it.
start vehicle, run through gears a couple of times then while engine running with vehicle on flat ground remove fill plug and top up until oil trickles out.
204 views
Usually answered in minutes!
×