1998 Ford Escort Logo
Jack C. Howey Posted on Nov 20, 2008

NEED TO REPLACE 1998 FORD ESCORT ZX2 WATERUMP

What Is The Easiest Way To Do That??

Is It Behind The Timing Belt??

Thank You - Jack

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Hot-Shot:

An expert who has answered 20 questions.

  • Contributor 20 Answers
  • Posted on Nov 20, 2008
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Nov 15, 2008
Answers
20
Questions
0
Helped
17646
Points
93


Water Pump 2.0L Zetec

Drain the cooling system.

Disconnect the negative battery cable.

  1. Raise the vehicle; and SAFELY SUPPORT!
  1. Remove the splash shield.
    • Remove the bolts.
    • Remove the splash shield.
  1. Loosen the bolts retaining the water pump pulley.
  1. Remove the drive belt.
  1. Position the A/C compressor (if equipped) out of the way.
    • Remove the bolts.
    • Position the compressor out of the way.
  1. Remove the water pump from the middle timing belt cover.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Does this car have an interference motor?

ford escort/ focus engine 2.0 l spi sohc 1997-2004 has been identified as an intereference engine and that means very likely valve to piston damage
( auto data timing belt information )
note-- up to 2002 year Ford has not recommended a timing belt interval for changing
Ford has however recommended a replacement every 120.000 miles using the service history as a guide
however good professional trade practice recommends every 60.000 miles ( 100.00klms) and the replacement work should include replacement of the crank and cam shaft seals and idler pulleys involved ( the biggest destroyer of belts is oil)
recommended labor time is 2 hours
if the belt has broken then head removal and valve work will add up to 5 hours to that time
0helpful
2answers

Serpentine belt diagram 2002 Ford escort zx2

The picture is for a zetec. Let me know if wrong diagram?
26017169-0d1su300qx55v1h5u01lpo5r-3-0.jpg
0helpful
1answer

1998 ford escort zx2 4cyl camshaft timing marks. how do you line up the cams when you are replacing the timing belt

there are no marks, special tools are needed to align the camshafts with the crankshaft.
0helpful
1answer

I'm trying to replace the serpentine belt on a 2002 ford escort zx2 but i can't seem to locate tensioner pulley

It may be like this:

"I just installed a belt on a 1998 ZX2 and used the tension release tool from underneath the car (safely jacked up and blocked) You should remove the right front wheel and plastic splash shield from wheel well (10mm socket). Use the tensioner release tool from underneath and rotate it towards the rear of the engine until you meet the lower heater hose. At this point, have another person use a tire iron / long screw driver, etc. to jam the tensioner pulley in place in order to get another "bite" on the tensioner pulley center bolt (use 13MM socket on the tool) You should have the entire belt pre-routed except for the AC pulley. This is the easiest one to install the belt on once tension has been released. Check for any looseness on the other idler pulleys as well as component pulleys."

Good luck! (rate if useful!!)
0helpful
1answer

How to install timing belt on 1998 ford escort ZX2 2.0

put #1 piston at TOP DEAD CENTER and align your cam marks . then time igntition timing with a timing light
13helpful
2answers

Need belt diagram for a 1998 ford escort zx2

Here it is. 13mm wrench to rotate tensioner

718d98e.gif
1helpful
1answer

I need to replace the drive belt on my 98 Ford Escort ZX2 manual transmission and need a diagram and to know where the tensioner is located. It is a single belt.

There are 3 possbile diagrams, depending on whether it's equipped with AC and engine type. The 3 are listed below. Thank you for using Fixya and please remember to return to rate this answer.
Greg

98 Escort Drive Belt Air #1
289d121.jpg


98 Escort Drive Belt Air #2
91346f7.jpg

98 Escort Drive Belt no Air
30a8765.jpg

0helpful
1answer

I have a 1998 ford escort zx2 and the back left

If you can still find a replacement left light lens of your 1998 ford escort zx2, you can replace it, of course. Just
take off the mounting screw of the lens, and take off the
defective lens. Then, you can mount the replacement.
0helpful
1answer

Need belt routing for a 1998 Ford Escort ZX2

Call a Ford parts dept and ask them if you can get a routing diagram they can fax or pick it up thats the best way label take weeks to get in so do that and keep the copy in your car file Please rate my response thank you very much
Not finding what you are looking for?

284 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...