My wifes Jeep Liberty has a rear wiper blade that seems to lock in the down position not allowing the arm to be moved even slightly in order to get your fingers to the lock that releases the blade. Do you know if there is a way to override it so I can fold open the arm and change the blade?
You should be able to raise it just enough to disengage it from the park ramp according to jeep...if that doesnt work try turning it on then shutting key off in mid stride
Turn your wipers off, using the stalk on the left side of your steering column. Turn your ignition off and remove the key.
Pull the wiper blade up to lift it to the service position. Pull the front part of the blade down to position it at an angle.
Pull back the lock pin on the center part of the wiper blade (where it connects to the wiper arm). This unlocks the blade from the wiper arm.
Grasp the blade on each side and pull it down (away from the extended wiper arm) to release it from the "U" clip.
Repeat the process for the other wiper blade, if desired. Removing the driver's side and passenger's side wiper blade is the same.
Install the new wiper blade. Open the lock pin on the new blade, and then insert it into the wiper arm "U" clip. Close the lock pin and lower the wiper blade to its normal position.
1,376 views
Usually answered in minutes!
The rear wiper gets stuck the motor runs and the wiper moves but I have to manually place the wiper on the class cause it gets stuck at the bottom
can not get the rear wiper arm to lock into place
×