20 Most Recent
1997 Jeep Cherokee - Page 9 Questions & Answers
The clutch will not disengage i have replaced the
Did you bleed the system after replacing the slave cylinder? The air has to be bled from the line. DOT 3 brake fluid should be in the clutch master cylinder. Bleed it till all the air bubbles are out.
If it is not engaging the starter check that the switch on the clutch pedal is being contacted when the clutch pedal is depressed.
12/21/2009 9:11:19 PM •
1997 Jeep...
•
Answered
on Dec 21, 2009
How do you check transmission fluid in 1997 jeep
To check the transmission level remove the dipstick and check to see how much fluid is on the dipstick, it will have a line to indicate full or anything below this line will need to add fluid. The vehicle should be warm with the temperture gauge above 180, and the vehicle should be running to get the proper reading. The fluid should be a bright red color anything darker may need changing, depending on the interval indicated in the owners manual.
12/19/2009 9:26:41 PM •
1997 Jeep...
•
Answered
on Dec 19, 2009
Trunk latch unable to open on 97 jeep sport
your latch is probably broken. your going to have to take the interior panel off the hatchback and look for any broken connection. if there is a broken connection, it should only be like twenty bucks to fix
12/19/2009 4:11:44 PM •
1997 Jeep...
•
Answered
on Dec 19, 2009
1997 jeep desiel air con not cold took it to a air
If they filled the system back up and the clutch on the compressor is engaging then your system should be pushing the R-134 around. If it is not cold you probably have a bad expansion control valve. This valve regulates how much and how fast the R-134 passes through. If it is not working correctly that is probably the cause.
12/8/2009 8:54:52 PM •
1997 Jeep...
•
Answered
on Dec 08, 2009
What size is the oil drain plug on 97 4.0 Jeep
The stock oil drain plug size isa 5/8 or 16 mm....But that doesnt mean that is the size or that the plug wasnt replaced ....your best bet would be to purchase or bring with you under the jeep a socket or wrench set from ten mm to 19 mm set ( 10,11,12,13,14,15,16,17,18,19) and go from there...hope i helped.....
11/14/2009 4:32:54 PM •
1997 Jeep...
•
Answered
on Nov 14, 2009
How to install hood latch 1997 jeep cherokee
Pretty much a simple thing...unbolt old one, making note of how linkage and cable was attached and put new one in it's place. Use the dirty area around the mount as a guide for positioning the new one. (Clean spot under the mount is a "footprint" place it there.)
11/14/2009 2:45:43 PM •
1997 Jeep...
•
Answered
on Nov 14, 2009
94 grand Cherokee trans problem
Could be a plugged filter, but generally there would be symptoms as the filter slowly restricts flow. Inside your transmission there are a series of shaft seals. If one upstream of the clutch drums fails, pressure will be lost and you will not get any clutch application. This can also happen if a control valve in the valve body goes bad, or the pump fails. Boiled down, something inside the unit isn't allowing pressure to go where it needs to go. All good trans shops will run a series of tests to determine if the problem is control or pressure related. Aside from the valve body, all else requires the transmission be removed and rebuilt. As the unit warms up the clearance between a worn seal and the shaft will increase . that's why it happens after warmup. This is not isolated to your trans but is common to all transmissions.
10/13/2009 1:39:28 PM •
1997 Jeep...
•
Answered
on Oct 13, 2009
Won't idle when cold
Test both the manifold air temp sensor and the coolant sensor. If either are out of range it can alter the cold start idle.
10/10/2009 2:28:27 PM •
1997 Jeep...
•
Answered
on Oct 10, 2009
I have a 1997 jeep Cherokee Sport with a 4.0L
What your are describing for symptons actually sounds like a sensor and a valve the starting problem is aa sensor Throttle position sensor and the stalling problem is your idle air control valve hope this info helps just make sure after you replace these 2 items that you disconnect the battery for about 10 minutes so the computer resets itself.
9/25/2009 4:50:06 AM •
1997 Jeep...
•
Answered
on Sep 25, 2009
Not finding what you are looking for?