20 Most Recent 2001 Hyundai Elantra - Page 7 Questions & Answers

Yes. I had a contact break in a connector on my transmission and it was shifting hard. Had to replace transmission. get it checked by a transmission service. They will know better. Maybe they can give you better news and fix it.

check for vacuum leak.

Connie,sounds like ur starter motor is worn out its draining all your power shorting out , the squealing noises is ur belt slipping when ur alternator is trying to charge up battery, & the clicking noise is also starter it 's the soilnoied is trying to work starter,.. first just make sure that all battery cables and chassis cables are clean and tight and chassis to engine are tight , hope this helps get back if necessary Connie

Check starter fuse able link it might b near exhaust manifold and it is getting hot if it is replace link and move it as far as possible from manifold cover it with electrical tape or heat resistant tape to keep cool same for all sensor wires

Most wiper motors r located under hood behind firewall under windshield u have to look closely cause it might b the arm that is missing or has broken clip that holds wiper in place

It is either located under hood or fuse box either under drivers side panel or passenger side

Had this before and i found a fault on the fuse board ,no supply the printed circuit maybe as i didnt go any further i just looped it from another fuse that had power via ignition switch through the radio fuse and it all worked but the fuse for the radio wasnt the one i looped as that had power for the memory it was another one that done the interior light and a thin bit of telephone wire done the trick so check all the fuses for power ,pull them out and check with a little 12v screwdriver light thing from the chinese shop ,right star trek is about to start goodnight

the positive lead has the larger terminal on it as the battery posts are different sizes. the small terminal goes on the small post and the wire runs to the engine or body as the earth .. Positive leads are coloured red while negative leads are black.

Replace the power steering belt. Make sure that it is tight.

It is a sensor located on the air intake to your engine. It controls how much air your car pulls in for combustion. Following is the wiki definition:The manifold absolute pressure sensor (MAP sensor) is one of the sensors used in an internal combustion engine\'s electronic control system. Engines that use a MAP sensor are typically fuel injected. The manifold absolute pressure sensor provides instantaneous manifold pressure information to the engine\'s electronic control unit (ECU - computer that runs the engine). The data is used to calculate air density and determine the engine\'s air mass flow rate, which in turn determines the required fuel metering for optimum combustion and influence the advance or retard of ignition timing.

check the fuel pressure regulator

buy the manual