1993 Porsche 911 - Answered Questions & Fixed issues

get the service an wiring diagram with diagram so that you fix the problem by your own http://toolsnyou.com/

Hello There
Ok,i will try to help you.
1.do the front motors-left-right (on the top of the windshield) work,or do you hear them working.or nothing at all.?
2.if yes does the top lift up a little and it does not go all the way?

let me know [email protected] so i can help you more.............
You said the hand brake switch works?The best is to connect the connector to ground to know for sure...

proporsche

Your 1993 911 has electronic fuel injection. When the engine is cold, it automatically richens the fuel mixture. This is the equivalent of closing the choke on an old car or tractor with a carburetor. When the car is going down hill, the car is not burning this excess fuel. You are smelling it coming from the exhaust. Once the car warms up, the engine computer automatically leans out the fuel mixture, essentially turning off the choke. Now you don't smell the fuel.

did you chk. to see if there is a fuse for injectors?

Try 5650 or 5648

USA car? if yes the manual is there to read https://eautorepair.net/Marketing/Default.asp

What year is your 911?

Most likely the cable is broken.

Inside latch release under the dash.

problem distributor cap or firing order

generally the yaw rate sensor its located at center of frame of the car , between front seats , also check each wheel rotation sensor

With tools and hard earned experience. Buy a basic tool kit from Harbor Freight tools and then buy a book on Do It Yourself auto repair, can be found under self help topics on Amazon I would venture to say. I have taken the liberty of suggesting a good basic low cost starter tool kit. Please follow the link 130 Pc Tool Set with Case

The assembly needs to be removed from the inside and taken out one of the doors. It is a cassette style with limited replacement parts. A great manual for this repair is indeed advised! There are too many procedures to cover in this forum. It is time consuming but not difficult. A used assembly from a salvage yard is a great way to go, if it has low miles/use.

Is the light limited to brake fluid level? Many times this is also an indicator of worn out pads or need to adjust emergency brake cable...Hope this helps.

Its very common for the battery holders to become loose from the circuit board. Open the unit, inspect the board for any loose solder joints, re-solder as needed and make sure the battery is inserted with the proper polarity.

hi there what year is it, your Porsche? [email protected]

Is it an automatic top ?

you more than likely have a dirty or bad injector in this situation, you can change your fuel filter and run a can of royal purple maxflow fuel system cleaner to a half a tank of gas if it is not too bad this will probably clear it up, if the low rpm miss is still there you need to bring it into a repair center and have a decarbonization done to the engine this will clean the injectors top end of the motor cataletic convertors and pretty much the intire engine

This code is usually present if your engine is running in a "Lean" air/fuel mixture situation. Good-Day!

What is wrong with it?