20 Most Recent 1989 Ford Crown Victoria - Page 5 Questions & Answers


Something is draining your battery when the car is off. Are your headlights coming on on their own when the car is parked? Sometimes the spring becomes weak in the switch and the headlight flash comes on and stays on. Try parking the car with the switch in the high beam position, closest to the dashboard. If you have a multi tester, go through the circuits at the fuse box with the keys out of the ignition and see if anything is drawing a lot of power, You will need to remove the fuse to do this.

1989 Ford Crown... | Answered on Apr 13, 2011


can take to most part's store and they will do it for free. Auto zone, advace, napa, ect.

1989 Ford Crown... | Answered on Mar 27, 2011


The multifuntion switch on the steering coulnm need to be replaced. If you don't have experiance disassembling coulmns then I would recomend you have it replaced at a good shop.

1989 Ford Crown... | Answered on Mar 19, 2011


universel joint is worn on the drive shaft thank you pierre

1989 Ford Crown... | Answered on Feb 26, 2011


look under your cars hood, and on the drivers side, look for a blackbox, that is indentified as fuses or relays, look inside , the fuel pump relay switch should be visable, you can also look into your owners manual, this item should be listed to refer by.

1989 Ford Crown... | Answered on Feb 14, 2011


A sensor failed or sense an error from your engine sensors

1989 Ford Crown... | Answered on Feb 10, 2011


Need more than that

It does nothing?
It clicks?
It turns over only

Has any testing been done and how?

We cannot answer a no start if you
have no spark for example and haven't
done any thing
Do you have fuel ?

What is the vehicles history up till
this problem?

1989 Ford Crown... | Answered on Feb 10, 2011


Here is a picture of the vac lines for your year:

chuckster57_19.gif

1989 Ford Crown... | Answered on Jan 26, 2011


It should be in front of the gas tank by top side.

1989 Ford Crown... | Answered on Jan 18, 2011


Not knowing your milage or what part of the country you live in if they use salt on the roads. The leak is coming form the three fuel lines going into the gas tank and fuel pump. The fuel pump is inside of the gas tank secured by a large slip ring seal. From the years gone by these lines rust and since they are under pressure they will leak through. You will have to drop your gas tank to get to this. This is a ugly all day expensive job. Replace the fuel pump which comes with the new seal and fuel lines assembly. I could sit here and tell you the step by step procedure but that will take hours. The very best thing you can do is buy a Haynes repair manual for your car and year at any auto parts store @ Advanced, Autozone. Read the step by step in the manual. I have used these for 40 years with all my vehicles and saved tons of cash in labor costs. Be prepared to replace the gas tank straps and additional fuel lines depending on how bad the rust is.
Good luck and thanks for your question and I hope my suggestions help. Don't forget to rate me.
burdfrenzy
Visit My eBay Store!
http://stores.ebay.com/Pittsburgh-Joes-Pants-Nat

1989 Ford Crown... | Answered on Jan 07, 2011


fuel sensor in tank is most likely bad or damaged

1989 Ford Crown... | Answered on Dec 24, 2010


misunderstanding what your asking do you want to no how to change your egr or have you changed your egr and it still throws code

1989 Ford Crown... | Answered on Dec 22, 2010


If you are sitting behind the steering wheel like you are going to drive,Its on bottom of Sterring and above brake padle

1989 Ford Crown... | Answered on Dec 16, 2010


Most likely the Float in the tank is bad and to find the Float,Put the car on a Car Rack get under at the tank and it should have a place on upper left to REPLACE THE fLOAT,BUT YOU NEED TO GET MOST OF GAS OUT OF TANK and good luck on finding a float for 89 Crown Vick.

1989 Ford Crown... | Answered on Dec 15, 2010


replace head light switch

1989 Ford Crown... | Answered on Dec 15, 2010


check fuel pressure. 35-40 psi

1989 Ford Crown... | Answered on Dec 09, 2010


Welcome to FIxYa.com


I hope i read the info you sent correctly that the brake light is staying on now? Ok if so check the brake light switch located at the brake pedal under dash( See Fig) and replace this switch. with a new one.leedavidian_68.jpg

leedavidian_70.jpgleedavidian_69.jpg

Thank you for using FixYa.com

Regards, Lee Davidian

1989 Ford Crown... | Answered on Dec 07, 2010


egr= exhaust gas recirculation valve

1989 Ford Crown... | Answered on Nov 22, 2010


Hi, under the dashboard, a bit above your left foot.

1989 Ford Crown... | Answered on Nov 21, 2010

Not finding what you are looking for?
Cars & Trucks Logo

250 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Crown Victoria Ford

  • Crown Victoria Ford

Most Popular Question

1989 ford crown victoria fuse box

  • Cars & Trucks
Loading...