Top 20 2004 Nissan Nissan almera tino Questions & Answers

At the back side (rear at the bumber)

Best going to a nissan forum to ask this Truck SUV Nissan Forum Nissan Trucks Forum

Is there any other codes? http://www.alldatadiy.com/alldatadiy/DIY~G~C45827~R0~OD~N/0/138181779/138629620/138629625/138629629/34853741/96340231/96340248/176614763/178118043 Try this link.

Check your wire diagram it could be IGN bad wire

P1715 is code input speed sensor

Confirm the timing marks were aligned properly by manually rotate the crankshaft up until piston number one is on a compression stroke, try to do this twice and make sure that the timing marks should be aligned accordingly with piston number one in top dead centre.

NISSAN MICRA ZS what year.???????????????? the whole assmbly or the bulb is bad. any auto body shop can show you or do the latter. the bulb is covered in the operators guide (glove box) of all cars. lost that?

ECM and TCM are both located under the dashboard, behind the glove box. You must remove the glovebox to access these modules. Remember that any yellow wires or connectors are for the air bags. You should probably refer to a service manual before accessing anything electrical/electronic.

Check the condition of your battery, is it fully charged or not by using your Volt meter for a voltage test and it should be more and not less than 12.5 volts, a load tester for testing it load and it should pass the test and a hydrometer for testing the battery specific gravity and it should be in a green column and also check the battery connections.

have the OBD codes read as there are a number of things that could cause these symptoms the OBD code will pinpoint the sensor/switch at fault, i would guess at an air/fuel problem but the OBD code will give a thorough diagnosis and save you time and money searching for the fault blind, keep me posted if you wish

The switch is inside within the light switch on the left lever. you have to roll it backwards.. Hope this will help

Gregory, your throw out clutch bearing is worn. You should just install a new clutch kit.

According to the diagram I just looked up it should be in the engine compartment fuse box position F3 and it is a 15Amp fuse. (F3) I think that means the one you are looking for is third from the top on the left hand side but I can't be sure without pictures or seeing it personally. If you want to take a pictures of the compartment fuse box interior and attach it to this post I could help more.

You need a square 8mm socket

If that is the only lamp not lite, when you turn the ignition key on & off,then you would assume, maybe, the bulb needs to be replaced. Lot of work to check that out

When you replace a speed sensor, the light should turn itself off after driving it. If it does not go off, than there is another problem.

sounds like you may have a bad maf sensor or wiring to sensor. you can reset it all day but the computer is still seeing a fault in that system, when you reset the code it is resetting but as fast as you reset it the computer picks up a problem in that circuit and turns the light right back on in a second,Have you replaced the mass air flow sensor or checked the wiring or tested the wiring ?

look on hooded vent area( under windshield whippers) sometimes there is a drain line that gets plugged with leave and dirt use a air line blow through and clean out this should do it

Because an engine revs up freely with no load on it in park and neutral is not a test for loss of power.

Go to www.busytrade.com,believe you come back with fruitful results!