X-10 Recent Questions, Troubleshooting Help & Support

PLW01 has 2 wires: Black wire connects to Hot and Blue wire connects to Load wire.
http://lib.store.yahoo.net/lib/aaaremotes/PLW01.pdf
Remove PLW01 and you have Hot and Load wires.
Standard light switch has two brass colored screws, and one green ground screw.
Connect either wire to either brass screw.
Connect bare ground wire to green screw.

First, what type of NV do have, manufacture it, what wrong with it, what do you want to make????stewbison

Sounds like one or more of the ignition coils are bad or going bad. that would be the first thing I would check.

The simplest way is to email them. A picture message will allow you to send to a email just put your email in where it asks for a phone number.

pull and turn side to side as these are called backstab connectors and theyre internally spring loaded

Hi, kindly get the code here : www.regionfreedvd.net/ www.dvdripper.org/dvd-region-codes-vs-ntscpal/ www.regionfreedvd.net/players.html
www.dvdreviewer.co.uk/Forums/...region_code/page1
Best Regards, Jay__45f7h

The dial with the letters is for setting the "house code". The dial with the numbers assigns a number for each controled device. If your neighbor's house code is the same as yours it is possible that their controller is tuning on your light. Change your house code to another number. Remember that all controllers and controlled devices must be on the same house code to work, so you have to change the house code on the remote also. If you don't want the remote to work just set it to a house code letter that is not being used by anything else. If you don't want the remote to work just for that device, just change the device number.

I'm sorry, what exactly are you asking? Are you trying to figure out the best way to give this as a gift? Please explain a little better and we would be glad to help.
Benjamin

I am confused a bit here, so what is the end device you are trying to turn on with the powermid extender?

How is the powermid attached to the end device?

It sounds like the device itself may be having problems and not the original powermid X10 if you put a new one in it's place and it still doesn't function...

Thanks, let me know
Tim

I do not know of any adjustments with the X10. I have seen were one was receiving some type of signal and turning on at 3am semi regularly. Try changing address then your only real choice is to replace the device. A better source of support would probably be x10.com

Ok that's great but we can not help you if we do not know what kind of car it is, you need to give Make, Model and Year and if you have a basic or premium factory radio setup.

Premium system would have a factory amp intergrated into it.

A basic would just be the radio and the speakers are powered off the radio not the amp.

disolder the microcontroller IC inside the monitor. then power on the monitor without IC . short all the terminals of the IC and remove then solder the IC and power on the monitor . your problem will be absolutely solved.

I haven't found a complete manual as such, but you can download each section (then print from browser) from the radio shack web site. I have provided the link below:

http://support.radioshack.com/productinfo/DocumentResults.asp?sku_id=61-2470&Name=Controllers%20and%20Remotes&Reuse=N

The Tektronix TDS series are notorious for the electrolytic caps drying out. They are SMT components and hard to replace if you do not have the proper equipment. Replace all of these on the main board ad all of your problems should be resolved. Good Luck!