Ragalta Water Heaters - Recent Questions, Troubleshooting & Support

Connect the water? Need more information, the water should be added above the unit, through a spout or device not connected directly to the unit.

Uhm....i.dont understand....are you asking about how to install a tub faucet, a tub, or a drinking fountain? Never the less, hot is always on the left from the users perspective. Mount it close to the drain or on an acrylic surround for drop in installation. And as far as the drinking fountain goes. You're screwed.

Do you have the original packaging? Search on-line for the manufacturer. Sears sells these. If possible, visit a Sears store and get a website or help number from a package. Then, make sure you have all parts assembled correctly. There is possibly circuit breaker or re-set button somewhere on the unit. Make sure the voltage matches your outlet.

Great question.On the back of the unit you should see two small adjustment screws, You will need a flathead screwdriver (generally) and you can turn these dials to increase or decrease the water temp.This unit may have a plastic panel on the rear that has to be removed first before being able to access these regulators.

Check for crossover:http://waterheatertimer.org/Crossover.htmlGeneh If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

I am not sure they are available to non Hitachi service centres. https://documentation.hitachiaircon.com/glb/en/pac/rua-at3s

Cannot find the fault code . There are vidoes on u tube saying how to reset thr code By pressing the reset button . If this does not work youcan ccontact vaillent on there web page . I have a mate who works for them i will ask him as well

Do I need to insulate this heater out in the shed? Freezing temperatures

Call a engineer

The P8 fault can mean many things when it pops up on your Mitsubishi Electric wall controller. The P8 fault is activated when the indoor coil sensor does not change the temperature for a set amount of time after the compressor is (or should be) switched on.

Where does the tube sensor go

This one looks the same.https://www.ebay.ca/itm/133397559348They are made by Harper Wyman and using that model number, this is the result.https://www.google.com/search?q=Atwood+RV+oven+control+valve+57294But this shows more that looks similarhttps://www.google.com/search?q=Harper+Wyman+oven+control+valveAnd then if we go here and Zoom in, you will see MTZ 22300https://youngfartsrvparts.ca/products/used-atwood-wedgewood-oven-thermostat-57294Which leads us here and the Specs Sheet.https://www.copreci.com/en/gas-cooking/product-range/thermostats/with-safety-and-thermostatic-flow-regulation/372-mtz-22300-seriesand from there to here, and Parts Town stocks them!List Price: $ 318.24https://www.partstown.com/fagor-commercial/fgrc12008712..