Luxor Televison & Video - Page 9 - Recent Questions, Troubleshooting & Support

Fault to its main board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/ . In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

hi!i have just the same problem,i made a factory reset and it looks like it helped no more flashing message

You should after factory settings ,when you tune the correct channel you must press store ,and if your doing it manual you must press store after each channel is found. That's should do the trick.

So what choice do you have - either find the sucker or get a new one. Try ebay eBayeBay

So if you have confirmed that your antenna is good and delivering sufficient signal strength, then the issue has to be with a defective front end or tuner section. Usually located on main board of set.

Hur?gi Man? is out for ?dinner. What do you? want??? Cake?s If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/