Cable is obviously broken inside
Take off the rubber tip and with gentle but firm pressure slowly bend the tip between thumb and forefinger towards you. The cap and tips are not glued and are held in place by two clips which break easily so be careful! Hold the bud upright with the Klipsch logos facing away from you and bend the tip towards you. They actually separate really easily. When finished they just clip back into place.
Plug 110v device in 220v outlet
The capacitor for rectification should in most times defect and rectification diode bridge can be shorted. fuse and maybe also a few fuse resistors
(resistors)
But if primary you cannot measure any resist on a 2 M ohm setting on multimeter on the power cord and its primary broken if you measure nothing between the 2
connector pins ( A transformer example)the powercord should be connected on the right and one of the 2 left points , if then its measure broken try it to solder the left wire of the powercord on the neighbour and try the transformer again BUT IN ANY CASE it should be refused with a temperature fuse similar to those you can find in the transformer when you peel off the covering but there are very thin and weak solderings on the primary winding wire you see connected on the blown tempfuse some of 125 or 127 degrees types are build in . FINALLY for the record regarding CE conformity regarding safety and fire insurance is the case every conceivable things that are here stated to be regarded as an opportunity to find out where the errors are, and it's for safety case to not overlap fuses a jumper, the insurance paid any damages arising from self-recovery therefore represent a warning
Not finding what you are looking for?