John Answered Questions & Fixed Issues

Question edited for clarity and turned around, changed 'tongue' to 'torque'. John Deere normally charge a lot for manuals, but the Gold Association posts it for free. They list the torques by bolt size on Page 13. You can also Search, click CTRL+F and type the word, press Enter. There are 80 mentions of 'torque'. http://golftechs.us/Manuals/JDturfgator.pdf https://www.google.com/search?q=john+deere+825i+intake+manifold+torque+specs ..

Question edited for clarity. Question moved from 'Garden' category. If it is stuck internally, you can use Throttle Body Cleaner spray. Externally, you can use WD40. https://www.google.com/search?q=John+Deere+Z445+EZTrak.+unstick+the+throttle ..

Are you sure that the battery is not hooked up backwards?

They appear to come in sizes from ride on toy to small toys. find the battery compartment cover, unlatch or unscrew the retaining screw and remove the old and replace with new. https://www.google.com/search?q=toy+John+deer+tractor ..

Limited information generic answer ----- Don't increase fuse amperage can or will cause damage to system and will not correct problem---- Both motors keep blowing fuse ? Was install done correctly correct wiring tight and correct ---as to engine (motor) disconnect power to starter and using a meter test circuit and then test starter for short ---as to hydraulic motor since you didn't specify what motor was changed do same disconnect and test circuit-- solenoid motor for short or open circuits

According to the Tech Manual, you DO have to remove the engine!

Click on the link below to get your image

https://encrypted-tbn0.gstatic.com/images?q=tbn:ANd9GcR83Tyb_NW9fkjDhQfTUh0MgUXpXz1uf5adqg&usqp=CAU

Google search shows the following web page for Peg Perego in Canada: http://pegperegocanada.com/where-to-buy/service-centers-juvenile

check and change the plugs also check the spark plug wire and make sure it's not cut or broken. last check the gap between the flywheel an the coil

hi you will get the info here http://www.mytractorforum.com/12-john-deere-forum or here http://www.tractorbynet.com/forums/john-deere

If you don't know how to get to the heater, how did you verify that you have a bad heater? you may not have a bad heater!

The emergency brake is engaged by a cable system. This cable is adjustable. Tighten the cable to put more pressure of the pads.

keep looking

can be either or a bearing a part can be bent or damaged need to inspect +

notify john deere code usually on disc package

Thermostat gasket

Is the PTO disengaged? Some of them have a pto neutral switch which keeps the tractor stationary when engaged and others allow you to move while pto is engaged. Depending on what you have will determine what happens. Also check the trans fluid and clutch adjustment.

Good day my light indicator says my brakes aren't engage but they are but it still wont start is this as simple as an adjustment or what?

Hello, Isa - I suggest you contact the John Lewis company directly and ask what the i60 error code means for your model of dishwasher. This is the link to the Contact Us page for the John Lewis company: https://www.johnlewis.com/customer-services/essential-information Best wishes.

Hello Travis, Was the hole always there, as in a manufactured hole, or are you describing a break in the housing? You can remove the cover plate to examine the gears for damage, or take it to a qualified Deere service center for diagnosis.