Heartland Refrigerators - Page 2 - Recent Questions, Troubleshooting & Support
The refrigeration part of the
its can be defrost problem.But still whats the exact model number of the unit.As per that the exact problem can be detected.
Is it old model or new model.?
---------
Is there any water leak noticed in fridge section , then yes its defrost issue.------
--- Keep updated with details.
5/4/2011 11:08:01 PM •
Heartland...
•
Answered
on May 04, 2011
The freezer is not freezing, only gets to
If the defrost hearer was not working you will have lots of ice build-up. It sounds like you have a drain line problem and the water is staying in the evaporator compartment. Try cleaning the drain out.
Won't cool. Lights come on when door is open.
Check to see if there is power getting to the compressor. If there is you probably just need to replace the overload relay that attaches to the compressor. There is the possibility you will need a new compressor, but usually you will hear something. There are 3 terminals on the compressor, one by itself, and two side by side. The one by itself is common, the other two are start and run. With a meter check common to start, then run. Both should be below 10 ohms and the start terminal has slightly higher resistance than the run terminal.
If you dont have power, you will have to trace power back to the control board, or the thermostat. I can give you more detailed instructions if you give me the full model number.
Hope this helps.
How to change the light in the refrig. compartment?
Some models are different...I hope this helps.
Replacing Light Bulbs
To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before replacing light bulb. After replacing light bulb, reconnect power.
To avoid personal injury or property damage, observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Fresh Food Section
(style of light shield varies)
1. Slide clear light shield toward back of compartment to release from light assembly.
2. Remove light bulbs.
3. Replace with appliance bulbs no greater than 40 watts.
4. Replace light bulb cover by inserting tabs on light shield into liner holes on each side of light assembly. Slide shield toward front of refrigerator until it locks into place. Do not force shield beyond locking point. Doing so may damage light shield.
Freezer (style of light shield varies)
1. Reach behind the light cover.
2. With firm pressure, press forward on the notches at the back of the cover and pull down the cover will open from the back.
3. Remove the cover.
4. Remove light bulb
5. Replace bulb with appliance bulb no greater than 40 watts.
6. Insert front tabs of light cover into slots in freezer liner and snap rear portion over light assembly until rear tab engages.
Ric
3/9/2010 7:00:56 AM •
Heartland...
•
Answered
on Mar 09, 2010
Russell Hobbs Fridge not working?
Humming is a classic sign that the start / run capacitor for the compressor has failed. Call for service, have it checked for gas and condenser cleaned.
..
How to remove drip tray at back of aeg fridge
On an AEG SANTO 3533, the tray sits on top of the compressor. There is a short metal "tunnel" on top of the compressor. The tray has a plastic clip in the middle which goes through the tunnel and latches up on the other side. To remove, reach to the back of the metal in the middle of the tray, press the plastic clip firmly down, and pull/wiggle the tray backwards horizontally to remove. Needed a torch to see clearly on mine. One of these things that's easy once you've done it once.
When Should You Consider Copper for Water Storage?
Copper has anantibacterial effect. Studies recommend storing water in copper containers for several hours before consumption to maximize this benefit. Some research suggests 48 hours. perhaps explore dedicatedcopper water bottlesfrom reputable sources for optimal water storage.
This refers to water, not juices.
Not finding what you are looking for?