I would like to know how to set up HAWKING HWDN3 USB 2.0 Wireless 300N Dish Network Adapter for Windows 10?
Have you logged into your router from a computer? Is it designed for win10 or a previous version of windows? Sounds like its for a previous version id try rolling back the driver and or using compatibility mode for what ever version of windows it was designed for. Select the app, right click and there and or in properties is compatibility mode. Ps is it your router that you updated? You'll need to log into it with a computer and RJ45 network cable. The usual network cable. And do the initial configuration like setting bssid and password Wi-Fi ect.
3/17/2019 12:51:31 AM •
Hawking...
•
53 views • 0 helpful votes
Hawking HWU8DD Vista Driver crashing Win 7.
there will be no win 7 driver as win 7 is no longer supported by Microsoft
to get a driver , you have to go to the manufacturers web site , find a down load for that model that is compatible for win 7 operating system
win xp is also not supported by Microsoft so there will be driver problems there as well
Where is ghe router 8 digit pin number for the hw2r1
Ping numbers (Or WPS numbers) are usually on a sticker on the bottom of most wifi / wireless devices. This is ONLY if they support WPS.
If you are sure the device supports WPS and a sticker is not on the bottom you may have to log into the device using a computer that is hard wired (Ethernet cable) to the device.
If you have lost the manual you can download a new one from here
http://hawkingtech.com/products/downloadfile/107.html
Note this link is for the manual to a Hawking HW2R1 ONLY.
Factory reset
Chapter15 The Init Button
The Init button is used for maintenance: Simultaneously press Init button and turn on (by plugging
in the power adaptor) the Server until USB1 LED indicator simultaneously blinks. After that, the
Server will do the following tasks:
A. Perform a Factory Default of the MFP server, which will restore most of the parameters and
settings to factory default values,
B. Perform a TFTP server. You can upgrade new firmware using any TFTP client tool.
Note: After performing the tasks mentioned above, you have to unplug the power adaptor and then
plug in the power adaptor to restart the Server.
HMPS1U Print Server for Multifunction Printers
Como resectiar unhw2r1
At the back of your device next to the WAN Port (internet port) you will find a small hole with a button inside it, turn your device off then press and hold the small button in while switching on your device, keep pressing down on the button for about 5 seconds, that will reset your to default settings.
Reset password on hps1p
I would suggest your download PSADMIN and Installation software from Hawking then push the reset button on the print server and start again.
Installing a hawking HOW2R1 Repeater and setup
The Setup Wizard will now prompt you to automaticallyconfigure your IP settings (recommended) and enter asecurity key if the network you are connecting to is anencrypted network. Enter the key and click Continue.If you do not know the security key of the network you are connecting to, consult your network administrator.
10/15/2013 10:19:43 PM •
Hawking...
•
462 views • 0 helpful votes
Don't have my istal disc
Clarification Question:What is the name and brand of the device that you want to have an installation disc?
3/10/2013 10:15:46 AM •
Hawking...
•
96 views • 0 helpful votes
Not finding what you are looking for?