Candy Washing Machines - Page 9 - Recent Questions, Troubleshooting & Support

If machine is new as you say it is covered under warranty. Contact the manufacturer for factory repair service.

could you tell me why my candy go 482 washing machine doesnt always spin and the stain vanish and 90 minute lights flash together

Would help to have the model and type...but typically if the tub is not agitating the coupling between the motor and the tub is worn out or broken. However, if it is spinning properly, it probably indicates a problem with the transmission. Really need to know what type of washer it is to help pin down the problem. Any "burnt" smells coming from the washer? Give a little more information and maybe we can figure it out. Top load...side load, make and model preferred. You can locate that information on a plate usually attached inside the door on most models.

I had that. Eventually found a dead mouse in the door seal. Sorry but it's true.

i have a candy activa cm1 146. no matter what i do the stop light is always flashing. Ive emptied the machine, turned it off at the mains, checked the waste pipe and currently trying to empty the filter, whilst the light is flashing it will not work on any programs???

NTC fault - temperature sensor detected as either open circuit or shorted ·Check wiring to temperature sensor Check thermistor

Not drained in time allowed - washing machine fails to drain water ·Check that filter is not blocked or obstructed ·Check drain hose is clear of any blockage or obstruction ·Check wiring to drain pump ·Check drain pump is not defective ·Check level sensor or switch Check wiring to level sensor

Not filled in preset time allowed - washing machine does not fill ·Check mains water pressure ·Check inlet hoses for kinks ·Check inlet filter ·Check water inlet valve ·Pressure switch fault Wiring fault