Air Purifiers - Page 8 - Answered Questions & Fixed Issues

This may help. For FAP02 and FAP03 reset the filtertimer by holding down the FILTERCHANGE button for three seconds.A red light comes on. Before it disappears, the light will start flashing quickly as you continue to hold thebutton. The timer is reset. https://www.manualslib.com/manual/565968/3m-Fap01-Rs.html?page=4#manual

Ioniser may help.

No. Those parts are no longer listed for sale.

The fuse is located inside the control panel. It is soldered to the circuit board, not mounted in a typical fuse holder. You will need a Philips screwdriver to disassemble the unit. You will need a soldering iron & solder to remove the fuse and replace it. You may want to a multi-meter to check the fuse. If the unit just stopped working, it could be a number of other issues than the fuse. The starter capacitor for the motor could be dead or some other issue. You must take precautions against electrical shock. You may need a technician to safely perform some repairs.

I had similar issues and by replacing the 2200 micro (Mu) Farad, 10 Volt capacitor on the PCB, all of my issues ceased. Below is a link with information supplied by "fixya" that explains the procedure/details. Hopefully this will solve your current issues. Good luck, Mike http://potlash.org/feast/2010/11/20/repairing-a-jet-afs-1000b/

PS Linda Haus of "Rockler" Technical Support was kind enough to supply me with this link.

check the remote batteries....

service manual is not allowed for Avery one....it is only with company service stations.

The lock symbol means the buttons are locked to stop kids etc or accidentally changing the settings. The owners book should say what to press to unlock it. Most of the time, 1 or 2 of the buttons need to be pressed down for a few seconds to unlock. I have no idea which buttons.

I am having the same issue. I've just replaced the filter and it started leaking out of this hole, where it never had before. I am thinking that maybe the filter isn't seated properly, and that's causing the leak. But I have attached a picture of the hole in question. Any advice would be helpful. Thanks!

Try it in google

Ask google with make and model

Go to google put it make and model the ask for filters

It might reset if u unplug it for 15 minutes then replug it in

All you need is to replace the UV light. Call your local Aerus or Aerus Electrolux store get one delivered to you! Easy peasy.

Spray lubricant onto the fan shaft as close to the fan body as you can. it will work it's way into the bearing

Its dirty and needs to be cleaned

do you have the make and model of the machine?

I would verify that all the parts you removed are properly seated back in their exact locations. There is undoubtably a safety switch that is not properly closed. A door, a panel, or a latch that is not properly seated and closing the safety switch is probably the cause.