Asko Dishwashers - Page 4 - Recent Questions, Troubleshooting & Support

so tighten or repair latch

Go on line enter make &model ask for manual download

Most all dishwashers have a rinse aid dispenser. It should have a screw off cap close to where detergent is added.

Most likely water has leaked into the bottom of the unit. There is a float and switch in there which detect water pooling in the bottom pan. When tripped, it produces the F2 error and constant running drain pump, like you describe. You could try just pulling the unit out and tipping it to drain the water (onto towels or whatever)... This might be a quick way to verify the issue, but it probably won't solve the basic problem of why it leaked. A better way would be to open the bottom of the unit (from either the back or the front, T15 driver required), and drain/absorb/vacuum the water out. Make sure everything is dry before starting it again. Then figure out why it leaked in the first place. It could be a clogged drain, debris in the drain pump, or some other leak. Ideally you can run the washer while watching under it for leaks. I found this PDF helpful for disassembly and testing instructions: https://applianceassistant.com/ServiceManuals/asko_dishwasher_3000_5000_series_service_training_manual.pdf

Probably main electrical connection at terminal box shorted.

if you read and followed your owner / operator manual then call back installer for problem repair

put it out from the source. check the pump to see if there is anything wrong with it. you can change the pump if there is a damage on it.

Check wire connections in electrical box.

I would guess a pump issue.

possible a securing device to stop it falling forward when the fully loaded draws are pulled out