Asko Dishwashers - Page 2 - Recent Questions, Troubleshooting & Support

How to Reset an Asko Dishwasher

1. Press the "Start/Stop" button.
2. Hold the button for three seconds and release.
3. Select the program and options on the front panel you want the dishwasher to use. Press "Start/Stop" to restart the dishwasher. You have now reset an Asko dishwasher.

It sounds like the door is distorted or buckled.I'm afraid you may need a new door if it cant be straightened.Also make sure the basket isnt stopping the door from closing.

I had to slide the dishwasher forward (undercounter installation)and tip it forward as far as possible. Water leaks onto floor, but then the internal controller seems to reset and the ASKO now works normally again. What kind of idiot would design a control module that does not incorporate a power-off interlock? FAIL FAIL FAIL - Bad, ASKO, Bad. Go to your room.

Flow meter problem might just need to be put on time fill or a new water sensor

new door perhaps

Power board must of blown

try an electrical supply business locally

Parts Schematic at the top of the page and every part listed. https://spares.bigwarehouse.com.au/index.php?cPath=69465_69466_86750 ..

The plate warmer heater could be drawing too much power.

You might try contacting Asko to see if they can provide assistance, and sell you the part. http://laundry.manualsonline.com/manuals/mfg/asko/t731_t761_t781.html

this could be the anti flood device has operated in the base of the machine. This is a polystyrene disc that is attatched to a microswitch. If there is water in the base of the machine this disc floats and turns on the pump

When the pump runs continuerly it is probably water in the bottom of the dishwasher, when you drag it out on the floor you can try to flip it to see if any water will run out of the mashine, or you an take the bottom front of to see if you can see any water, there should be a water float in the bottom that is being activatet by the water that can leak from the washing cabinet to the bottom of the dishwasher.

has the garbage disposal been replaced recently? - check that the drain plug on disposal s popped out https://www.hometips.com/wp-content/uploads/2012/05/remove-dishwasher-plug.jpg - check that the drain line has a loop in it, i prefer the high drain loop. http://jbch.us/uploads/3/4/3/0/34305337/dwhighloop1500_orig.jpg

If you are REALLY handy, look for a stuck relay. The timer may control the motor directly without triggering a relay. If that's the case you need a new timer. Usually the wiring diagram (schematic) is on a folded piece of paper stuck under the dishwasher or sometimes in back. I have seen a lot of stuck relays AND bad timers. Good Luck

First of all, don't pre-rinse the dishes. Check the water temperature, it should be between 120 and 140 degrees. Be sure you are not partially blocking the dispenser door so that it isn't opening.

Does anyone have an Asko dishwasher model 1776 type dw953 for sale or are getting rid of

Solution1 worked after all steps, but had to cut the power (unplug) and replug, then it startedwell ! Thanks !!!

I had tried several failed attempts to fix this problem. Finally I got on my knees and asked God to make the dishwasher run in Christ's name. The dishwasher just completed it's first cycle without any problems.