Question about AVR-200 Receiver
...wire connections(center and the other 2 pair) Have you gone through the setup and set the speaker menu so that the unit knows you have other speakers. Check it even if you did. Check that you are not ...
Arcam A70. I have a pair of Tannoy DC3 speakers, as well as a speaker switch unit for 6 in wall/ceiling speakers. I hooked up the Tannoy speakers to "A" and the speaker switch to "B" on the amplifier.
...speakers has blown fuse replaced with a 1.25 250v but keeps blowing any suggestions I would guess that during the move, the speaker wires crossed and smoked one of the output amp sections. The output ...
...wire).That can be done with a ohmmeter or a less desirable way and thats a process of elimination simply hooking the speakers back up one at a time till it fails and then thats the culprit
...arcam alpha 7r turns on fine (orange light turns green) when you try and up the volume it clicks out and green goes back to orange, and the rear right hand side gets far too warm. thanks for any ...
...amp smokes or tries to protect itself from heat, shorts and overloads by refusing to turn on or stay on. Overloads can be from excessive periods of high output or marginally low impedance loading by ...
...amp attempts to protect itself from heat, shorts, overloads and operator exuberance by refusing to turn on or stay on. Overloads can be from excessive periods of high output or marginally low ...
...Arcam A65 amplifier, after using abount 10 minutes and the amplifier will switch to standby protection mode, Can any body tell my why please? Thank you Depending on the volume level and how many ...
Question about CS26 Speaker
...to the pressure on the speakers. Check to see that the speakers are hooked to the correct impedence output of the amplifier. Also, wire length affects impedence and shortening the wires might
Question about CS26 Speaker
...speakers are ok and they are. Can somebody kindly suggest a checklist of things to do See if the Speaker is blown or check for fuses on the back of the amps. Next switch the speaker wires at the back ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions