Questions & Answers for: unit runs but never has water in bucket

unit collects water but periodically continues running despite full bucket which is flush in unit, what could be causing this it doesn't happen everytime. there is a floater switch on the machine over

unit runs fine, cools, all systems "go". When it has run for 12 hours or so and lets me know it is time to empty the bucket, there is no water in the bucket. I have to wheel the unit out the door, tip

...water level sensor,problem by pass and test run unit if ok replace switch. Unit will not run. Pull plug and restart will run for about 5 seconds then turns off. "bucket full" circuit seems to be the ...

...unit to drain the water and we have check the bucket which has no water in it. The display that shows the humidity level you desire is at 1 and will not change when the up or down arrows are pushed. ...

...unit. Water bucket is correctly installed. Hi, This is usually caused because of dirt buildup where the water runs out into the bucket... Find the little tube or spout that runs the water into the ...

runs out on the floor. What is wrong? The drain hole of drain tube, that transports water to the bucket is clogged. To solve this problem, do the following: Remove the water collection bucket and look

runs but leaks water, water won't stay in bucket Denise, there are several things that can cause the problem. 1. The water collection bucket is not installed properly. Turn the unit OFF and remove

...unit is lower or the hose runs up hill even the slightest incline will cause the water not to flow backing up to the machine * Hose must remain flat and in a down hill flow to the drain if you are ...

...unit runs but the full bucket light remains on and no water is in the bucket if water full light stays on the compressor wont start and remove water from air , investigate why light stays on ? is ...

unit, we can see water coming out of the drain, but for some reason it ends up running down the back of the inside of the unit instead of going into the bucket. I tried running it on pump mode instead