Questions & Answers for: Mazda Millenia turbine speed sensor

NOT START IT IS GETTING FUEL, SPARK, SCANNED IT WITH COMPUTER AND IT SAID ENGINE SPEED SENSOR COULD THAT MAKE IT NOT START? This could be crankshaft sensor. If it is, yes it will stop it from starting

turbine speed sensor circuit malfunction. which is more likely to cause my car to down shift in the middle of me driving it? THE TURBINE SPEED (PART OF THE TRANSMISSION CONTROLS) SENSOR IS THE CULPRIT

...you may have bad plugs i would try that first changing them out or it may be a bad speed sensor or throttle posistion sensor. Could be bad set of spark plug wires too, will do the same thing

...speed sensors, fuel filters, fuel pump and O2 sensors. Mazda did not solve the issue nor found any codes for the transmission. Could this be the knock sensor pulling these codes and casing the car to ...

speed from there. I've looked under the hood and I found a loose blue and yellow wire coming from the back of the motor. I looked it up in a Chilton wire diagram and it seems to be coming from the

...speed sensor and possible oxygen sensor or catalytic converter if vehicle has covered more than 150.000 miles then cat could be going home but ??? to test this you need a special machine to put a ...

turbine speed sensor If you were replacing a speed sensor on a 1998 Mazda 626 where would it be located?You can find the vss by going under the car, on backside of transmission facing the floorboards.

...speed sensor i been searching like crazy on the internet and i cant find any picture of where the speed sensor is located. its for a 97 mazda Millenia. its not the abs speed sensor its the other one ...

Where is the speed sensor in a 2001 mazda millenia The speed sensor for the speedometer should be in the side of the transmission.

put it on it just blows the same speed you might have a broke speed sensor for the blower motor. it should be easily accessed under the dash board and is a couple screws to pull and it comes right out