...transfer case slipping out of 4 wheel drive It has push button 4X4 and will only engage if the truck is stopped, otherwise it will just grind. Then when accelerating there is a grinding and a clunk ...
...transfer case is low or out of fluid. 2-The drive shaft may be out of alignment due to worn front or back U joints (thus the clunk on shift) 3-the shift lever is out of alignment with the shift ...
...there is a load on it but when i turn right it runs fine. any help would be greatly appreciated Sounds like it could be the differential, or the transfer case. 4X4? did you check the engine
...start hearing the humming noise. Fluid levels good I'm thinking its my transfer case. any thoughts. I would check for a bad wheel bearing on the rear, also check the u-joints on the drive
...transfer case rebuild to try and fix the problem. All this started after i had a intake gasket blow and kill the motor, i have replaced the motor with an identical small block 350. Any ideas? can of ...
Usually answered in minutes!
878 Questions
795 Questions
754 Questions
575 Questions
561 Questions
