Questions & Answers for: Xante transfer belt

...transfer belt may not be returning to the proper start position. The normal solution to this, if it persists after a restart, is to replace the transfer belt. no, but just been told its a P/U issue ...

...transfer belt and then power the printer back on. If the error remains then I will need you to check the life remaining on the transfer belt. Also make sure the transfer belt is not torn. 917 relates ...

transfer belt. To the left you will see a plastic move it to the left and you will see a white plastic with two sensor one at each end. This clear plastic get dirty and then you have bad registration.

Transfer belt error 356 My new transfer belt will stop working around 70 % in one cl30 and will contineu to work in another cl30 what is the solution there is what is called a etb electron static ...

transfer belt under the CMY drums. envelopes have air in them and can bounce along the bely after the black has printed, and seeing the toner is powder and not yet fused on, the toner touches the cyan

...transfer belt on the left once the belt is removed, you will see a long grey plastic cover, gently push this to the left to revel the 3 rectangle lenses, clean them with a very soft cloth...put it ...

change transfer belt Ilumina Transfer Belt Replacement Ilumina Transfer Belt Replacement

magenta and the black clean all the registration sensors on the imaging drums and at the fuser end (there are 3 under a shifting piece of white plastic on the left side after transfer belt is removed

...of the fuser. Not easy to get to it, I do not recommend taking it apart unless you have a new one standing by, cause you are going to need it. Drum and transfer belt ok not so with the furser

...Transfer belt would be next Remove Drum Rear Key's and interchange the Black drum with the Cyan Drum. If you get the same problem, the most likely problem is cause by the transfer belt. The ...