Question about XNT Transducers XNT 9 20 T Mounting Unit
383c transducer gives nothing but noisy red feedback at medium or high speeds My transducer is installed as instructed but when at mediium to high speeds it just shows a bunch of garbage. Red feedback
Lowrance LMS522c transducer On my boat I am replacing a Si-Tex HE-705 ...with a Lowrance LMS 522c...My question is can I use the installed transducer from the Si-Tex on my new Lowrance.... Probably ...
Question about X52 Sonar Fishfinder Without Transducer
can i install 2 x52 units on bow and stern with Can i install 2 x52 units on bow and stern with one transducer if so how do i install Yes you can...you would have to install a rotary switch between ...
Question about Fishfinder 400c With Dual Beam Transducer
Have just installed a Garmin 140 on a tracker alum. boat. I have the transducer what appears to be at least 3/8 " below bottom of transom. I lose the bottom at least 40% of the time. Do I need to go ...
Question about Fishfinder 400c With Dual Beam Transducer
...transducer installation should the transducer on a Elite 5 be in line with the bottom of an aluminimum hull or the bottom of the ribs running along the hull thanks try and mount the transducer at the ...
...transducer. See the "Installation Manual", which is different than the "Operators Manual". Section 3 page 9 and 10. You may have to enter your units of measure (Knots vs MPH, etc), and then it will ...
how to install transducer should transducer be tilted slightly down Transducers usually have a 6 degree tilt down looking from the boat .
Question about Elite-5 DSI Color Combo Fishfinder/Chartplotter with GPS & Transom Mount Transducer 000-10236-001
...transducer installation guide for Lowrance, this is pretty standard for all transducers. Pay attention to how the boat sits in the water when trolling for level setting to match in water. ...
Question about Elite-5 DSI Color Combo Fishfinder/Chartplotter with GPS & Transom Mount Transducer 000-10236-001
installing transducer when installing the transducer does it need to be flush with bottom of hull or abut 1/8in bellow I assume you're talking about a transom mount transducer. Best if the leading ...
Question about Fishfinder 565 With Transom Mount Transducer
Where can I install the transducer for a lowrance hd down scanner on my ranger 621 I have the kicker motor on the right side the transducer for hds8 is glassed in I would suggest getting a transducer ...
Usually answered in minutes!
1,678 Questions
1,343 Questions
1,187 Questions
1,096 Questions
889 Questions