Questions & Answers for: Mercury Villager tps sensor

TPS sensor on the throttle body. Throttle position sensor. It is a very delicate adjustment after replacement with a voltmeter. If not that, replace the dropping resister. go here for files and photos

Transmission shifts hard when changing gears, even at low speed? sounds like dropping resistor or TPS sensor. http://groups.yahoo.com/group/villagerquest/

my villager surges a little when going down the raod clean MAF sensor with spray carb cleaner several times. go here for more help. Could be TPS sensor too. http://groups.yahoo.com/group/villagerquest

...tps, egr, and nock sensor problem. If i replace the tps will i need to calibrate it? And as far as changing the nock sensor. how hard it is? thanks in advance, -randy never, ever replace a knock ...

...position sensor is located at the intake of the of the engine opposite side where the throttle cables end LOOK AROUND THROTTLE BODY THATS WHERE IDLE AIR SPEED CONTROL AND TPS SENSOR SHOULD BE

...sensor. Clean heated wires with carb cleaner. TPS readngs are good. fuel pressure should be 43 engine off, and 34 engine running. try disconnecting front oxygen sensor for a day & see if better. ...

...TPS sensors have 3 wires. One is voltage in(5Volts). One is signal return , the other is ground. Unplug the sensor and check for voltage (with key on) and check for ground. If you need instruction on ...

...stalls runs fine off idle Just with the info you gave me it sounds like a TPS SENSOR..(Throttle Position Sensor)going bad or else possible an O2 sensor..(Oxygen Sensor)..really need more

what is a dropping resister or tps sensor? The tps is a throttle position sensor mounted on the throttle body.  It measures the position of the throttle for the computer.

How I find the TPS in my Mercury Villager 2000 All TPS Sensors are on the Throttle Body, usually T-20 Torx Bit to remove All sensors have to be tested or your just replacing a good part for no reason