Questions & Answers for: suction pressure

...have lack of pressure and the pump is not 6 months old The pump is not properly primed due to suction leaks. Check for leaks in your suction line. Check also the integrity of your suction check

...suction pressure will be high, your head pressure will be lower, not sure how clean your condenser coils are so its hard to say how high. Your amp draw on your compressor will be lower than normal. ...

...suction pressure is 90psi R-22 suction line is warm but not hot 90 psi is very high for R22....low for R410 refrigerant. If leaking by the head pressure and suction pressure will be close to to the ...

...-13. but i want more .-18 to -20 so pls tell me the correct suction pressure details. If it is R22 then it will be about 11psig on the suction side. This should give you a -18 degrees across the

...SUCTION PRESSURE WAS 42 AT THE GAUAGE. BUT THE SUCTION PRESSURE WOULD DROP PRESSURE THEN RISE 10 PSIG FOR A FEW SECONDS THEN DROP AGAIN. COULD LNOT FIGURE IT OUT, CAN YOU HELP You have to let the ...

...410 Tapped the suction line @ the compressor & the 410 pressure is @ 240. I have a 20 deg split thru coil but how is it possible @ this suction pressure? thats a good question? due you mena 410 ...

low suction and low head pressure I have low suction and head pressures What is your suction and discharge pressure? Sea Breeze

...suction side pressure with A/C gauge connected to suction side of compressor - if pressure is low clutch will not be energized do to low pressure cutout switch. Add freon or 134A to bring up suction ...

...pressure tank has no suction, brand new out of the box We just bought this and installed it and it has no suction and does not pressurize The issue you're describing with your Pedrollo 80L horizontal ...

...Suction pressure: The suction pressure should typically be in the range of 30-45 psi (pounds per square inch) for a 404a refrigerant system. This pressure corresponds to a saturation temperature of ...