Questions & Answers for: GMC C1500 stop base unit flashing

stop but after awhile it will start back up can you tell me what is the probleem your fuel injectors may be clogged or your fuel sending unit may be operating for a while then cut off causing the fuel

...hazards stop flashing when brakes are applied.The brakes light switches in the 90's were really weird because they also incorporated the abs system.Good luck,let me know what ...

turn signals work,then out of the blue stop working.my hazards stop working. 1994 gmc 1/2 ton 4x4 check the fuse for the hazard light and turn light. also check the bulbs for all light make sure they ...

i have a 84 GMC with a 305 ,I getting gas in the vacuum tube going to the vacuum modulator on the tranny .Main vacuum source is from the base of carb ,Should I run my vacuum for tranny from the intake

...stop screw to get the right base idle 6-800 rpm while slowly blocking off the iac hole inside the throttle body(may stall a couple of times but persist) with this in mind this is also the way to get ...

...THEN COMES TO A COMPLETE STOP. THEN THE CAR SHUTS OFF. A FLASHING 'F' APPEARS ON THE DASH BOARD. PLEASE HELP!!!! Check transmission fluid and filter. If the transmission is not yet damaged it will

engi lite flashes 16 times thought this service engi lite flashes 16 times thought this service was free! Engine lite flashes depending on the year of this car, a flashing check engine light means a ...

'88 GMC C1500, whenever I'm below 1/5 a tank of gas and completely stopped, when I hit the accelerator it dies just before switching into 2nd gear. While coasting, I can go WOT and the engine starts ...

1995 gmc sierra 1500 automatic transmission idles fast, and late shifts Do you have a service engine light on? If so the first thing to do would be to check for what codes may be stored. You can also ...

...stop working. If you have another used one try changing it out. I would just try to replace them instead of trying to fix one. There are three or four on the TBI and are easy to change out, or just ...