Questions & Answers for: Ford Ranger slave

Question about 1994 Ranger Supercab

1 Answer

Clutch slave hydraulic retainer clip not avail. I had the clutch line leading into the clutch slave on my ranger ripped out, got new line, cannot buy clip without slave. 1994 4.0L V6 Ford 5 speed. I ...

Ad

Question about 2002 Ranger Regular Cab

2 Answers

...but still can't ingae clutch. Is there a bleeder some were There should be a bleed valve on the slave cylinder but some of them are quite difficult to get to. If the master was empty you need to ...

Ad

Question about 1995 Ranger Supercab

1 Answer

how to install a slave cylinder on a 95 ford ranger The easiest way to deal with this problem is to order the complete preblead slave cylinder kit. You can, just go with a new slave cylinder but ...

Question about 1998 Ranger SuperCab

2 Answers

...how do I adjust it? The clutch is not adjustable,it is a fluid clutch.It has to be a leak,or the slave cylinder,and,or, the master cylinder are bad,It does not have to be leaking to be bad,but it ...

...ONLY!). If it is empty there is a leak. It is usually one of two places. The master cylinder or the slave cylinder. The master is mounted to the firewall and has a piston in it that pushes fluid ...

Question about 1997 Ranger SuperCab

2 Answers

Do I need to remove the transmission on my 2002, 2.3 Ranger to replace the slave cylinder? Thanks Yes, unfortunately your slave is wrapped around the input shaft. Thanks for using FixYa. No you ...

Question about 1997 Ranger SuperCab

1 Answer

i have a 94 ford ranger 4.0.. i've replaced the slave cylinder 2 times.. i put a new one in it and everytime about two weeks later it goes bad again and i have to keep putting fluid in it to get ...

Question about 1997 Ranger SuperCab

2 Answers

i am relacing slave valve on my 95 ranger have xmission seperated from engine is it necessary to completely remove xmission or can it be accessed from side panel and replaced Yes it does because the ...

Question about 1997 Ranger SuperCab

1 Answer

JUST INSTALLED NEW CLUTCH, SLAVE CYLINDER AND MASTER CYLINDER ON 1986 FOR RANGER. CAN NOT GET CLUTCH TO BLEED, JUST ABOUT THE TIME I GET SOME CLUTCH, THE SLAVE SEAL STARTS LEAKING AT THE SEAL BEHIND ...

I changed the slave cylinder and now my clutch will not disengage. I have even bleed the slave and its still stuck. What now? If I don't take the truck out of gear before I try starting it and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...