...screw right into the drywall and then another typical screw goes through the mounting plate into this anchor. I recoment getting metal anchors as the plastic ones break easily. These hold MUCH better ...
...drywall screw gun Screw magnet missing How do i replace it and where can i buy one You have to replace the entire depth guage assembly (the front plastic pieces where the bit driver is). Unfortunatly ...
Question about SG45 4500 Rpm Drywall Screwgun
it might be because you are drilling into hardwood studs or supports behind the drywall. If this is the case, you may have to pre-drill (pilot hole) for each screw so the screws are easier to drive in
Question about SG45 4500 Rpm Drywall Screwgun
...screw should only "dimple" the drywall. It should not tear the paper but should be below the plane of the drywall. To check depth run a putty knife over the screw heads. If you hear it hit, screws ...
Question about E-Z Ancor Self-Drilling Drywall Anchor
...drywall anchors, some of which will not allow a too-long screw to be used. But the plastic ones shouldn't have this problem, because the tip (inside the wall) is supposed to split apart. However, you ...
Question about E-Z Ancor Self-Drilling Drywall Anchor
drywall screw 1" above the patch outline, centered. Align the wood in the hole with the lines you made on it at 2" back from the ends. Screw the drywall screw into the wood. Do the same at the bottom.
screw. any idea. thanks drywall guns wont spin until you put pressure on the tip, load a screw and put it to the wall (or whatever) add pressure and pull the trigger a dry wall screw has a cluch in it
...a utility knife this can be easily accomplished. After you cut and remove the damage, remove all screws or nails from the studs giving a good surface for the new drywall that your going to replace ...
Question about MH052FNCA 18000 BTU High Wall 410A Heat Pump Indoor Unit With Good
screw the new drywall patch to the plywood. Next is your adventure in taping & mudding & sanding the drywall to finish the patch. Last, paint it to match the rest of the wall... or repaint all
Question about MH052FNCA 18000 BTU High Wall 410A Heat Pump Indoor Unit With Good
...falling out or screw into wood that supports the plasterboard. Drywall screws are used to hold plasterboard/drymall sheeting, in place, not for fixing to plasterboard as the board will fall
Usually answered in minutes!
350 Questions
260 Questions
250 Questions
168 Questions
217 Questions