Questions & Answers for: Fujitsu scanner lamp adjustment

Question about M4097D IPC Path-Through Flatbed Scanner

3 Answers

...lamp for (B). Most of these solutions will require a service call. Contrary to the scanner hotline solution, the most expensive solution may not be the correct one. Remember, optical alarms are ...

Ad

Question about M4097D IPC Path-Through Flatbed Scanner

2 Answers

Fujitsu M4099D The bulbs do light. Sounds then like a loose camera cable , dirty glass, or white background plate. In case the glass and the camera mirrors are clean, please check the front lamp if ...

Ad

Question about M4097D IPC Path-Through Flatbed Scanner

1 Answer

...scanner. I think there are about three screws that secure the plate that surrounds the output jacks. With the screws out, the whole rom board comes out like a sliding tray. The fuses are round and ...

Question about fi-4120C Path-Through Scanner

1 Answer

...scanner ON. Open the ADF and press Cover open sensor to see if the lamp lights. If not, the error is caused by the defective lamp. 5. Is the optical unit dirty? 6. Are the cables damaged? 7. Are the ...

Question about ScanPartner 620C Flatbed Scanner

1 Answer

...scanner I get after a few moments the following error on the panel control. Led amber goes on, green Led stays blinking and the red Led stays also blinking. I could not see if the lamp goes on. Any ...

Question about fi-4750C Flatbed Scanner

1 Answer

...scanner error When I SCAN A DOCUMENT EITHER THROUGH THE FEED TRAY OR ON THE FLAT BED, i GET AN: FRONT SIDE OPTICAL ALARM ERROR WITH THE FOLLOWUNG IN SENSE KET = 0X4, ASC = 0X680 Try a flatbed scan ...

Question about fi-5750C Flatbed Scanner

1 Answer

Fujitsu fi-4340C changing the bulb My scanners top bulb is burned out. I'm trying to find a way to open up the top to replace the bulb. Any ideas? Open up the ADF ****. Remove Two Silver screws ...

Question about fi-4340C Flatbed Scanner

1 Answer

...scanner. Worked for a while then it showed Front Side Optical Alarm. I tried to clean sheet path, and replaced roller and pickup pad. Still the same error. Does anyone has the similar experiece and ...

Question about fi-5750C Flatbed Scanner

1 Answer

lamp, heater, CCD, or inverter- Connector disconnectedDoes the same symptom occur after turning OFF and ON the scanner? Check the scanner.Is the White sheet guide (glass) in the FB cover dirty? Remove

Question about fi-5750C Flatbed Scanner

1 Answer

how many lamps are in fujitsu 5750c scanner? how can i replace them? Hi Albert,There are two CCD lamps inside Fujitsu fi-5750c Duplex scanner.One is ADF Front and the other is ADF Back.To replace them

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Fujitsu Office Equipment and Supply Experts

Cindy Wells

Level 3 Expert

6688 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

k24674

Level 3 Expert

8093 Answers

Are you a Fujitsu Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...