...SCANNER LAMP IS NOT GLOWING AND THE SCANNER IS WORKING PROPERLY;THE STEP THAT YOU HAVE TO TAKE ARE: 1.OPEN THE SCANNER AND SEE IF THE CARD IN SCANNING UNIT IS ALL RIGHT NOTHING IS BURNT. 2.IF ...
Question about Scanjet 5590 Flatbed Scanner
scanner 5590 - "lamp error" Every time I try to scan it starts, then says "lamp error" - the lamp appears to be on however --- is it worth fixing? Is this just a bulb replalcement? Can a layman do it?
...scanner the lamp not working it will tend to stuck up Make sure that the lock switch is set to unlock. Look for it on the scanner body. If it is unlocked, then unfortunately the scanner is probably ...
Bad or fading scanner lamp (-4430) Replace scanner lamp
Lamp error in HP Scanner my HP Scanjet g2410 gives lamps error when the command is given for scanning. w2hat are the technical solutions? It would cost more to replace the scanner assy than a new ...
...out! You can certainly get a replacement lamp but due to the complexity of replacing it I recommend you get a new scanner. In most cases the lamp will cost you more than the scanner did
...lamp assembly. Step: 1. Check to see if their is no SCSI ID number conflict. 2. Check the SCSI cable connections. 3. Run scan test again. ** Make sure the scanner is on the list of the system device ...
...because of lamp error. Does the lamp in the scanner come on at all? If not, then it is most likely bad. You can try disassembling the scanner and check that the lamp connectors are not
...on) although the carriage works. It will occasionally work if I unplug and re-plug it. it means the lamp does not work , try to restart the scanner , if still lamp off , it means faulty scanner ...
...lamp error, is this a hardware error. Yup! The lamps have a limited lifetime (or it could have just failed prematurely due to some other reason). For the cost of parts, it would be cheaper to buy ...
Usually answered in minutes!
244 Questions
109 Questions
80 Questions
73 Questions
80 Questions
