Questions & Answers for: reset button amana air command

...Amana Air Command 80 The noise sound like something was stuck and then when I turned the furnace off it made a little louder sound then it was like it died, Could it be the blower? blower bearing can ...

Amana Gas furnace, Air Command 80 SV. Does not ignite. The blower turns on, then gas valve opens. I can hear a mechanical switch close, which is probably the igniter control. But no spark, no flame. ...

...Our Amana Air Command 80 is making a loud squeaking sound every time it turns on. It goes away after a while, but the duration is getting longer now. Any ideas? sounds like bad fan motor ...

Amana Air Command 80 blower won't come on Amana Air Command 80 with EWC zoning condenser working but blower won't come on, zoning system calling for both zones Sounds like fan relay or fan motor ...

amana gas furnace,air command 80 sv. does not ignite blows cold amana gas furnace,air command 80 sv. does not ignite blower motor turns off and on Hi check out the pressure switch jump it out and see ...

Amana Air Command 80 SSE gas furnace will not stay running I have a Amana Air Command 80 SSE gas furnace. The furnace exhaust blower will start then it will ignite, then the cold air blower will start

amana air command 80 SV. When I try to get heat, it won't work. I have pushed on the control board and it comes on for a short while then stops again. Again, I push on the control board, or move wires

...Instructions. This manual is to be used by qualified HVAC technicians only. Amana .... Gas Furnace Upflow/Horizontal Induced Draft A Air Command 80

amana air command red light is on and it says to replace control . what control? high efficiency 80 gas furnace bad control board