Questions & Answers for: Hyundai replacing ecm

Question about Hyundai

1 Answer

2000 2 door accent removed airbag fuse (mistake) when replaced the dash warning light for Airbag now stays on it flashes as normal when vehicle started but then is steady on you have to reset the ecm ...

Ad

Question about 1996 Accent

3 Answers

ECM location for 96 Hyndai Accent Where is the location for ECM connector? SMOG report says it may have water damage and the OBD2 is not communicating with vehicles computer. Shop recommend repair ...

Ad

Question about 2001 Elantra

1 Answer

IT IS NOT WORKING CAN I FIX THE MAP SENSOR FOR THE ELANTRA 2001 Run this diagnostic Test Procedures  1. Check if DTC P0110 is set in addition to DTC P0105 or P0106. If DTC P0110 is set, go to ...

Can not read ecm code for emission check in GA The car runs great and has no check engine light on. The CEL comes on during initial start as it should, then goes out. In GA, they need to make sure ...

01 accent gl 1.6 liter auto,air ;engine lite on,trouble code 342, (cmp, sen low) three wire sys. posit 1 tests bat volt. posit 2 is suppose to read 0-5 volts @700-3000 rpm;but reads 12.1 running and ...

Question about 2001 Elantra

2 Answers

no crank 2001 hyundai elantra gls, we were driving, car died, now wont crank. new batt, cables look good with new ends, nothing, just a click, have power to all accessories and lights. hooked up ODBII

...installed new alt and battery and fuse good and still no charge on battery check 10 amp ECM fuse. Your alternator voltage is regulated by the ECM. If the fuse is good, consider replacing the

Question about Motor 1999 Elantra

1 Answer

I have a 1990 exel gls with a 1.5 4 cylinder port fuel injected. The original ecm would no longer run the engine, but will still comunicate with my scanner. I have tried 2 different ecm's which will ...

Hyundai diesel has a problem in the throttle i have cod P 201 P0201 - Injector Circuit Malfunction Cylinder 1 The Powertrain Control Module (PCM) or Electronic Control Module (ECM) checks the ...

Question about 2004 Santa Fe

1 Answer

My Santa Fe cuts out when driveing then i have trouble restarting, i have had the cam shaft censor replaced, help please. Why did you replace the Cam Sensor? Was there a DTC P0340 in the ECM ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 Hyundai Santa Fe
2004 Hyundai Santa Fe

1,503 Questions

2001 Hyundai Elantra
2001 Hyundai Elantra

1,180 Questions

2000 Hyundai Accent
2000 Hyundai Accent

1,131 Questions

2006 Hyundai Sonata
2006 Hyundai Sonata

1,254 Questions

2001 Hyundai Accent
2001 Hyundai Accent

1,082 Questions

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...