Questions & Answers for: Ford Ranger replace r134

Question about 1992 Ranger

2 Answers

92 ford ranger hi. my truck just won't stay running. replaced fuel pump and ran for a short while, then quit. replaced fuel filter, mass air flow sensor. checked relay switch, fuel cutoff switch, ... ...

Ad

Replacing an intake manifold gasket on 1993 ford ranger 4.0 I am replacing an intake manifold gasket and found that the replacement gasket did not extend all the way to the front and back of the ...

Ad

Left front sway bar has lost the lower bolt. Replace bolt & rubber or the whole thing? Left front sway bar has lost bolt & rubber.Is it best to replace just the missing parts or replace the whole ...

Question about 1984 Ranger

2 Answers

i cannot replace my fuel filter i have an 84 2.8 carbureted ranger went to replace the fuel filter and the seal to the threads broke so now it spins in place leaks gas and wont come off You'll have to

Water pump is out. How do I get id out to replace Water pump is out opn my 1993 Ford Ranger. How do I get it out to replace it?!!! is it a 4 or a 6 cylinder engine, well you need to take off the fan ...

Question about 1988 Ranger

2 Answers

innstaling the heater core Inspect/Replace If it is necessary to remove the heater assembly, the cooling system must be drained before removing the heater core. When a heater core leaks, a new heater ...

Question about 1997 Ranger SuperCab

1 Answer

...R134. A/C runs about 30 sec, then dumps entire charge, either inside evaporator housing or possibly thru tubing seal on liquid line under accumulator. If the orifice tube is clogged, would that cause ...

...cuts in and out and won't stay engaged? Truck has been parked for several months, battery died. Replaced battery, started truck and turned on AC. The compressor cuts in and out (much like the one ...

Replaced carb and was running fine except for a skip when cold. Wasn't satisfied and replaced wires and left old dist and rotor on. Now only starts with pedal held down to floor. Once running will

Question about 1983 Ranger

1 Answer

...idles fine. Also when its acting up the RPM's will surge back n forth. I have done the following: Replaced all Spark Plugs. Replaced all Spark Plug wires. Replaced Distributor Cap. Verified Firing ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...