Questions & Answers for: Dodge removing the motor cover

...1.5 inches distance from the cowl cover and the upper arm approximately 2.5 inches from the lower arm. Operate the wiper motor and check that the wiper motor parks when the wiper switch is

...removing the blower motor assembly. Failure to do so may cause accidental deployment of the air bag, resulting in unnecessary SIR system repairs and/or personal injury. Disconnect and isolate the ...

cover. need to change the front blower motor. you don't need to mess with any covers, the blower motor is located behind the glove box,under the dash.you will need to remove the three screws that hold

...motor cover Disconnect and isolate the negative battery cable, then wait 2 minutes before proceeding with the removal. This will effectively disable the air bag system preventing possible personal ...

...Removing the trim panel to access the rear blower motor Disconnect the wiring harness connector from the accessory power outlet, if equipped. On long wheelbase wagons only, remove the quarter trim ...

...cover. drain oil and remove oil pan. put a block under the crankshaft and jack to release weight on motor mount. remove front motor mount (by serpentine belt) remove belt. remove compressor and ...

...removing the blower motor assembly. Failure to do so may cause accidental deployment of the air bag, resulting in unnecessary SIR system repairs and/or personal injury. Disconnect and isolate the ...

...motor cover. Remove the 4 screws holding the cover. Unplug the wire harness and back the harness out of th heater case.Remove the 3 screws holding the motor and remove the motor. Should the new motor ...

...cover 3. Remove attaching screws or mounting nuts from pivots 4. Disconnect wiper motor wiring harness connector 5. Remove 3 motor mounting bracket-to-body bolts 6. remove motor bracket, motor and ...

...motor cover Remove the A/C-heater blower motor cover. Disconnect the blower motor wiring connector. Remove the blower motor wiring grommet and feed the wiring through the blower motor housing. Remove ...