Questions & Answers for: Chevrolet Silverado 2500 remove lock

lock in 4wd on this model? PLEASE HELP. Sounds like your front actuator in the axle is not working..What you can do for now instead of buying a new one is remove the front actuator.It is a threaded in

...remove lock plate. some have a small 3/16 allen screw holding key tumbler in others have a flat spring to depress. If the actual switch (not lock cyl) is bad you will have to lower the colum from the ...

...Remove the lock plate retaining spring using a Lock plate press. Remove the directional switch screws (3).. Lift that switch out of the way to remove the ignition lock screww Pull out ign Lock ...

...switch had been busted with a screwdriver. I need to replace the old one, but I am unsure how the remove it from the steering column. disconnect the batt. remove the horn pad, remove clip that ...

...Remove the lock cylinder. WARNING Considerable force may be necessary to break this casting flash, but be careful not to damage any other parts. When ordering a new lock cylinder, specify a cylinder ...

...remove the driver seat (4 nuts on floor and wiring). Pull cable thru floor and replace. Reverse procedure to install. Lock the cable and clip at steering colomn, but leave the clip off at tranny. The ...

REMOVED THE STEERING WHEEL AND TRYING TO REPLACE THE PLASTIC HORN ASSEMBLY UNDER THE STEERING WHEEL LOCK CANT GET IT OFF!!! u need a Lock Ring Removal TOOL

...a bolt. You need to remove the steering wheel, lock plate, and turn signal switch to gain access. You will need special puller for the steering wheel and a special tool for removing the lock

removing ignition swithch cylinder Takes some special tools ,you could rent them from the parts house,steering wheel puller,lock ring compressor ,has to come out with the wheel off ,not like a ...

How to remove front axle This is simple Take locking nut off remove the hub it will come right out always replace the wheel barrings when you go back with it I have this on U Tube Go there and it will